Possible Reasons for Subaru Tailgate Not Opening
There could be several reasons why your Subaru tailgate is not opening. Here are some possible causes based on the information from various sources:
1. Power Tailgate Sensor Issues: The issue with the power tailgate not opening could be related to sensor problems. This can cause the tailgate to beep three times and not open as expected.
2. Faulty Switch or Button: A faulty switch or button could also be the cause. This can result in the tailgate not opening even after unlocking it using the keyless entry system.
3. Battery Related Problems: Issues with the battery, such as a dead battery, can also lead to the tailgate not opening as intended. Resetting the power rear gate (PRG) by disconnecting the battery for a few minutes might resolve the issue.
4. Height Adjustment Setting: In some cases, the tailgate may not open fully due to a height adjustment setting that limits the opening to a specific percentage. Ensuring that this setting is adjusted correctly might resolve the issue.
5. Lock Actuator or Electrical Problems: Problems with the lock actuator, blown fuses, damaged wiring, or issues with the latch itself can also prevent the tailgate from opening properly.
Possible Solutions
Based on the information provided, here are some potential solutions to try:
1. Manual Override: If the power tailgate is not opening, using the manual override feature by pressing and holding the release button for a few seconds might allow you to manually open the tailgate.
2. Resetting the Power Rear Gate: Disconnecting the negative lead of the battery for a few minutes can reset the power rear gate without losing radio station presets.
3. Reprogramming the Tailgate: In some cases, reprogramming the tailgate by disconnecting both battery terminals and touching them together away from the battery for a short period may resolve the issue.
4. Checking for Sensor or Switch Issues: It’s important to check for any sensor or switch issues that might be causing the problem. If necessary, consider seeking professional assistance to diagnose and address these issues.
5. Consulting the Owner’s Manual: Reviewing the owner’s manual for specific instructions on troubleshooting and resetting the power tailgate system might provide additional insights.
Remember, if these solutions do not resolve the issue, it may be best to consult with a qualified technician or the dealership for further assistance.
I hope these insights help you address the issue with your Subaru tailgate!
Contents
- How do you reset the lift gate on a Subaru Outback?
- How do you reset the tailgate on a Subaru?
- Why is my liftgate not working?
- Why is my lift gate not working?
- How do you manually open a liftgate on a Subaru Outback?
- How do you manually open a Subaru hatch?
- Why is my automatic liftgate not working?
- How do you reset the hatch on a 2018 Subaru Outback?
- Why won t my Subaru outback tailgate open?
- How do you reset the tailgate on a Subaru Forester?
How do you reset the lift gate on a Subaru Outback?
To reset the electronic rear latch mechanism, close the gate, press and hold the exterior latch button for 10 seconds. You will feel it re-locking the latch. At this point, the gate will open, close, and lock normally.
How do you reset the tailgate on a Subaru?
How to reset your Subaru rear hatch. When this issue is occurring, the car will beep three times each time you press the rear gate button. The natural response is to release the button once the car beeps. To reset the rear door, keep holding the rear hatch release button until you hear a soft “thuck”.
Why is my liftgate not working?
The most common liftgate issues can be traced back to the motor or motor start solenoid. If you hear a clicking noise when the switch is activated, more than likely you have a bad solenoid. Using a small jumper cable, bypass the solenoid by putting direct power to the motor to see if it will run.
Why is my lift gate not working?
The most common liftgate issues can be traced back to the motor or motor start solenoid. If you hear a clicking noise when the switch is activated, more than likely you have a bad solenoid. Using a small jumper cable, bypass the solenoid by putting direct power to the motor to see if it will run.
How do you manually open a liftgate on a Subaru Outback?
Press the button on the underside trim above the license plate the rear gate will automatically. Open you can also press the lock button on the rear gate to simultaneously. Close the rear gate and
How do you manually open a Subaru hatch?
Now this is the fun one so you can do this hands-free. So if your hands are full of things just use the back of your. Hand. Hold it in front of the badge.
Why is my automatic liftgate not working?
A lift strut issue, a malfunctioning power hatch, and a bad switch or button are some of the common reasons why a power liftgate may malfunction. The buttons, fuses, and electrical connectors must be inspected to diagnose a power liftgate issue.
How do you reset the hatch on a 2018 Subaru Outback?
Pull all the way up. And all the way back down to reset the limit switches. Okay that’s it.
Why won t my Subaru outback tailgate open?
You will want to open and close all doors and the hatch. Lock and unlock the vehicle and try it again. If it is still an issue then try a reset of the liftgate module. You can do this by disconnecting the battery (both positive and negative terminals).
How do you reset the tailgate on a Subaru Forester?
Let’s. Say you’re out at the mall. Doing some shopping you get out to put your bags in the hatch. And it’s just not opening with the either the button or the the button on the hatch.