Why wont my ignition turn in my Chevy Impala?

Possible Causes for Ignition Not Turning in Chevy Impala
There could be several reasons why the ignition won’t turn in your Chevy Impala. Here are some possible causes based on the search results:
1. Key Stuck in Ignition Lock Cylinder: The automatic transmission shifter may fail, or a wire may break near the shifter, causing the ignition key to become stuck in the ignition lock cylinder.
2. Transmission Not Fully Engaged in Park: If the shifter is in park but the transmission did not fully engage, it can prevent the key from turning all the way back and getting stuck. In this case, giving the car a good push while it’s running in park may help engage the gear and allow the key to be turned off and removed.
3. Ignition Switch Issue: Problems with the ignition switch can also cause the key to get stuck. This could be due to a faulty switch or an electrical issue.
4. Steering Column Lock: In some cases, the steering column may lock up, preventing the key from turning. This could be due to a mechanical issue with the column lock.
5. Other Electrical Issues: There may be other electrical issues, such as a dead battery or a problem with the power supply, that can prevent the key from turning or the ignition from functioning properly.
Troubleshooting Steps
Here are some troubleshooting steps you can try to resolve the issue:
1. Ensure the Car is in Park: Make sure the car is in the park position. Sometimes, wiggling the shifter while trying to remove the key can help.
2. Check the Transmission Engagement: If the shifter is in park but the transmission did not fully engage, try giving the car a good push while it’s running in park. This may help engage the gear and allow the key to be turned off and removed.
3. Check for Steering Column Lock: If the steering column is locked, try turning the steering wheel back and forth while attempting to turn the key. This may release the column lock and allow the key to turn.
4. Inspect the Ignition Switch: If none of the above steps work, there may be an issue with the ignition switch. It is recommended to have a professional mechanic inspect and potentially replace the ignition switch if necessary.
If these troubleshooting steps do not resolve the issue, it is advisable to consult a qualified mechanic or contact your local Chevrolet dealer for further assistance.
Please note that these suggestions are based on general information and may not apply to every specific case. It is always best to consult a professional for an accurate diagnosis and appropriate solution.
I hope this helps! Let me know if you have any other questions.

Why is ignition stuck in lock?

If your car is in Park, but the key is still stuck, you may have locked your steering wheel (an anti-theft feature). Crank you car, unlock your wheel, and it should come out. If still no go, your ignition cylinder might be damaged, and you probably should see need a specialist.

Why won’t the ignition turn in my car?

A car key can get stuck in the ignition if either the key or ignition cylinder is damaged or warn, if your steering wheel lock is on, your battery is flat, or you haven’t properly selected ‘Park’ in your automatic transmission.

How do you unlock the ignition switch?

And mark that spot with an X. If. You drive a Saab this is not your excuse to fumble your passengers leg. The final step to unlocking your ignition lot is to take your favorite handgun.

When I put my key in the ignition nothing turns on?

If you attempt to start up your car but the engine won’t turn over and the dashboard lights up, then you most likely have an issue with your battery. You could have a damaged or corroded battery terminal, which is stopping the engine from starting up when you fully turn the key.

What happens if the ignition switch doesn’t work?

A bad ignition switch will have problems with starting the engine, keeping it running, or engaging other systems when the key is turned. You might also have issues turning the key. What causes an ignition switch to fail? Most often, wear and tear is the culprit from thousands of key cycles and heavy keychains.

Why won’t my ignition barrel turn?

Slide the key in and out a few times.
Insert the key completely, then slide it back out. Repeat this process a few times to try to move any debris that may be caught in the cylinder. Then, crank the engine. If this works and it doesn’t happen again, it’s probably a one-time thing you don’t need to worry about.

How do you fix an ignition switch that won’t turn?

While this probably means that the steering column lock has been engaged. And you won’t get to turn the steering wheel. It’s an anti-theft device. But don’t worry it’s easy to disengage.

Why won’t my ignition switch turn in my Chevy Impala?

First is to try tapping lightly on the end of the key when it is in the cylinder. Second is to try a shot of compressed air in there. If these do not do anything, then the cylinder needs to be removed as part of the ignition switch and drilled out.

Why wont my key turn in the ignition Chevy?

A key not turning could be caused by the key itself, the lock, or a variety of components in the security system. Outside of something being wrong with the key, the technician may look for issues in the ignition cylinder or in the car’s security computer, which on many models is separate from the engine’s computer.

How do I know if my ignition starter switch is bad?

The most frequent symptom of a Bad Ignition Switch is trouble starting your vehicle. The ignition switch is only one piece of the car’s ignition system, which also consists of the ignition coil, distributor, spark plugs, plug wires, and other additional related components.