Where is the temperature sensor on a Dodge Durango?

Location of the Temperature Sensor on a Dodge Durango
The temperature sensor on a Dodge Durango is located in the following position:
3.6L Engine: The Engine Coolant Temperature (ECT) sensor on the 3.6L engine is installed into a water jacket at the rear of the cylinder head on the left side of the engine. It’s important to note that hot, pressurized coolant can cause injury by scalding, so the cooling system must be partially drained before removing the coolant temperature sensor.
For the 4.7 liter engine, the Coolant Temperature Sensor is typically near the thermostat, which is the sensor that drives the gauge readings.
For the 2011-2013 models, the sensor is located on the driver’s side cylinder head at the back.
It’s essential to follow the specific instructions for the particular engine model when locating and working with the temperature sensor.

What happens if you drive with a bad temperature sensor?

If your coolant temperature sensor is failing or has failed, do not continue driving your vehicle. You should get it fixed right away. A faulty sensor can lead to overheating. This will cause damage to your engine as well as other components, which will be very expensive to fix.

What happens when coolant temperature sensor goes bad?

If your car has only one a bad engine coolant temperature sensor may result in your fans. Not starting or on the other hand the fans might be on all the time if the readings from the sensors are

What happens when a temperature sensor goes out?

A malfunctioning coolant temperature sensor may send an incorrect “cold” signal to the ECU, tricking it into believing the engine isn’t hot yet. The ECU will then adjust the fuel injection, ignition timing, and variable valve timing, further raising the engine’s temperature and causing it to overheat.

What is the symptoms of a bad temp sensor?

4 Signs Your Coolant Temperature Sensor is Faulty

• Faulty Coolant Temperature Sensor – 4 Common Symptoms.
• Fuel Consumption Increases.
• Check Engine Light Flashes.
• Engine Overheating.
• Black Smoke from the Exhaust.
• Don’t Ignore the Warning Signs.
• Reliable Car Maintenance with Professional Auto Experts!

Does the coolant temp sensor control the fan?

Yes, the coolant temperature sensor is an important component in controlling the radiator fan in many modern vehicles. The coolant temperature sensor monitors the temperature of the engine coolant and sends this information to the engine control module (ECM), which uses it to determine when to turn on the radiator fan.

Where is the temp sensor located?

The coolant temperature sensor will be located directly behind the coolant pipe. In most modern cars and vehicles, this is present behind the right cylinder head that is located right underneath the air intake pipe. Will a malfunctioning Coolant Temperature Sensor cause a check engine light?

Is coolant temperature sensor easy to replace?

Replacing a coolant temperature sensor is a fairly manageable task for a DIY mechanic. Here are some general tips and tricks that you should take note of when it comes to engine coolant temperature (ECT) sensor replacement. Note: Make sure you know where the sensor is before you start.

Where is the coolant temp sensor on a 2014 Dodge Durango?

The engine coolant temperature sensor is located in the front of the engine right above the serpentine belt.

Where is the coolant temperature sensor located on a 2012 Dodge Durango?

This attachment from the 2011-2013 FSM should have the info you need. The sensor is located on the Drivers side cylinder head at the back.

How do I check my temperature sensor?

To test a temperature sensor with a multimeter, set it to measure resistance, clip one probe to an outer sensor connector and the other across from it. Submerge in hot then ice water, note readings after a few seconds – around 250 and 1000 ohms respectively.