AHG Auto Service » Make » Ford » Where is the temperature sensor on a 2007 Ford Focus?

Where is the temperature sensor on a 2007 Ford Focus?

Location of the Temperature Sensor on a 2007 Ford Focus
The temperature sensor for a 2007 Ford Focus is located under the hood of the vehicle, specifically in the engine head between the 2nd and 3rd spark plug. It has a black and copper appearance and is responsible for sending the signal to turn on the cooling fans.
If you need to purchase a replacement, it typically costs between $20 and $40. It’s important to note that in the Ford Focus 2007 with the 2.0L Duratec motor, Ford uses just one sensor for both the cylinder head and coolant temps, and it is located in the head between the 2nd and 3rd spark plug.
It’s worth mentioning that the coolant sensor should be on the T-stat housing and would include a female electrical connection, but it’s noted that it’s rare to find a 2003-2007 Duratec engine Focus with a coolant sensor.
In summary, the temperature sensor for a 2007 Ford Focus is located in the engine head between the 2nd and 3rd spark plug, and it plays a crucial role in regulating the engine’s temperature and triggering the cooling fans .
If you have any further questions or need additional information, feel free to ask!

What happens if you unplug the coolant temp sensor?

If you are unplugging your vehicle’s coolant temperature sensor, you will definitely run into some problems. you will set a trouble code, check engine light on, radiator cooling fan should come on. Don’t drive car with the sensor disconnected.

Will a temp sensor throw a code?

Possible bad Coolant temp sensor. Since the temp gauge doesn’t go to the normal range the car is most likely getting out of range readings from this sensor(such has -40°C) and it will then throw a code like P0115 which means Engine Coolant Temperature Sensor Malfunction.

Where is the temp control sensor located?

The ECT sensor is often located on the engine block, usually near the thermostat housing. On some engines, it may be located on the intake manifold. The sensor measures the temperature of the coolant and sends a signal to the computer. The computer uses this information to adjust the ignition timing and fuel mixture.

Are there 2 coolant temperature sensors?

There are two temperature sensors in some vehicles, one to send information from the engine system to the control unit and another from the control unit to the dashboard. The device follows the principle of dependence of potential difference in temperature.

How do I reset my outside temperature sensor?

After replacing an Ambient Air Temperature (AAT) sensor, the sensor data must be reset by either driving the vehicle at speeds consistently about 20 MPH for at least 5 minutes to update the filtered data or perform the multiple button press reset procedure to update to the current raw value.

What are the symptoms of a faulty temperature sensor?

If the computer detects that the engine is heating up too much, the performance settings will be adjusted to prevent overheating.

  • Faulty Coolant Temperature Sensor – 4 Common Symptoms.
  • Fuel Consumption Increases.
  • Check Engine Light Flashes.
  • Engine Overheating.
  • Black Smoke from the Exhaust.
  • Don’t Ignore the Warning Signs.

How do I know if my coolant temperature sensor is working?

If your vehicle starts to use a lot more gasoline than usual, or black smoke is starting to come from the exhaust pipe, these are indicators that the coolant temperature sensor in your vehicle could be defective, and needs to be replaced.

Why is my car reading the wrong outside temperature?

Therefore, the temperature your car’s thermistor is recording is the warmer temperature over the roadway, which has been heated by the sun. This can be 10-plus degrees warmer than the actual air temperature, which is measured about 6 and a half feet above a grassy surface, typically at an airport location.

Does the coolant temperature sensor control the fan?

Yes, the coolant temperature sensor is an important component in controlling the radiator fan in many modern vehicles. The coolant temperature sensor monitors the temperature of the engine coolant and sends this information to the engine control module (ECM), which uses it to determine when to turn on the radiator fan.

How do you reset the outside temperature sensor on a Ford Focus?

And keep pressing for five to ten seconds. And then release it your ambient temperature sensor will reset. I hope this will fix your problem.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment