The starter relay on a 2008 Dodge Ram 3500 diesel is located underneath the fuse panel under the hood, also known as the TIPM (Totally Integrated Power Module) on the driver’s side front panel under the hood. However, if the relay has been previously replaced, it could be located under the fuse box/TIPM or tucked in the fender wall. This is because a new relay may not have the same mounting hardware as the factory relay, so it might be loose without the mounting plate.
Please note that the starter relay on a 2008 Dodge Ram 1500 with a 4.7 engine is soldered onto the circuit board inside the TIPM module, which can be expensive to replace.
I hope this helps! Let me know if you have any other questions.
Contents
- Where is the relay switch for the starter?
- Why is my Dodge Ram 3500 diesel not starting?
- Where is the starter relay on a 2006 Dodge Ram 3500?
- Where is the starter relay on a 2008 Dodge Ram?
- How do I know if my ignition relay is bad?
- How do you know if your starter relay is bad?
- Why is my diesel engine turning over but not starting?
- How do I know if my starter relay is blown?
- What does it mean when a diesel engine turns over but doesnt start?
- What are the symptoms of a broken starter relay?
Where is the relay switch for the starter?
Most often, a true starter relay is a small black cube plugged into an electrical fuse/relay box in the engine compartment, whereas a starter solenoid is (in most cases) attached directly to the starter on the engine (although it is sometimes located elsewhere in the engine compartment).
Why is my Dodge Ram 3500 diesel not starting?
The most common reasons a Dodge Ram 3500 won’t start are a dead battery, an alternator problem, or failed starter.
Where is the starter relay on a 2006 Dodge Ram 3500?
The starter relay is located on the left fender.
Where is the starter relay on a 2008 Dodge Ram?
The 2008 Ram 1500 starter relay location is beneath the fuse panel under the hood. You will come into problems with the battery during the life cycle of the vehicle. There can be a leak, causing the fluid to spill out.
How do I know if my ignition relay is bad?
Car suddenly stalls while operating: One of the most common symptoms of a failed ignition relay is a car that suddenly stalls while operating. If the ignition relay shorts, burns out, or otherwise fails while the engine is operating it will cut off power to the fuel pump and ignition system.
How do you know if your starter relay is bad?
Symptoms of a Bad Starter Relay
Here are some common symptoms: No response when turning the key or pressing the start button: The most obvious sign is when you try to start your car, and nothing happens; no engine cranking, no sound, just silence.
Why is my diesel engine turning over but not starting?
Possible situations include clogging through air bubbles or debris in the fuel filter, air disallowing proper flow, an empty fuel tank, dilution due to water, or the presence of debris. Fuel pipes may also be clogged, cracked, ruptured, bent, or constrained, cutting off the fuel supply.
How do I know if my starter relay is blown?
The engine started erratically. The headlights dim when you try to start the engine.
What does it mean when a diesel engine turns over but doesnt start?
check to see if there is fuel in the tank. If you run a diesel tank dry, it can be very difficult to get it running again, as you have to get the fuel pump primed again. Check the fuel filter to see if it has any water in it. Also check to see if the filter is dirty.
What are the symptoms of a broken starter relay?
How To Tell If Starter Relay Is Bad?
- The Vehicle Is Dead. The most obvious symptom is a completely silent car that does not respond when you turn the ignition key.
- Starter Making Clicking Sounds.
- Occasional Failures In Starting The Vehicle.
- Starter Does Not Get Switched Off.
