OBD2 Port Location on Subaru BRZ
The OBD-II port on a Subaru BRZ is typically located under the dashboard on the driver’s side. It is often found near the steering column or where the driver’s side door meets the dashboard when it is closed. Specifically for the BRZ, it’s right above the driver’s right knee.
It’s always recommended to check the vehicle owner’s manual for the specific location of the OBD-II port on your particular make and model of Subaru. All Subaru vehicles from 1996 and newer have an onboard diagnostic (OBD) port, including the BRZ.
If you need further assistance in locating the OBD2 port on your Subaru BRZ, it’s advisable to refer to the vehicle’s owner’s manual for specific guidance.
Contents
Do all cars have an OBD2 port?
Since 1996, every single car is legally required to be equipped with an OBD II port. Before this, manufacturers were free to adopt this technology by any means they wished. This variation introduced significant costs for mechanics who were required to buy different tools for each manufacturer’s design.
Does my car have OBD-II?
Does my car have OBD II? All 1996 and newer model year gasoline and alternate fuel passenger cars and trucks are required to have OBD II systems. All 1997 and newer model year diesel fueled passenger cars and trucks are also required to meet the OBD II requirements.
Where is the OBD2 reader located?
The OBD-II port is usually located under the dashboard, beneath the steering wheel column (1 – 3 in the diagram below). If not located beneath the steering column, look for the port in the areas indicated by numbers 4 – 9.
Does every car have a OBD port?
Since 1996, every single car is legally required to be equipped with an OBD II port. Before this, manufacturers were free to adopt this technology by any means they wished. This variation introduced significant costs for mechanics who were required to buy different tools for each manufacturer’s design.
What year did Subaru start using OBD2?
The OBD-II system incorporated in all Subaru vehicles since 1996 complies with Section 1968.1 of the California Code of Regulations (OBD-II regulation), and all applicable Federal Clean Air Act regulations.
Does my car have OBD2?
If your car was built after 2001, it’s likely that you can use any OBD2 scanner. Petrol vehicles build from 1996 and and diesels built from 2008 should have an OBD2 port that you can use to connect a car scanning device. You’ll usually find the OBD2 port on the drivers side somewhere under the steering wheel.
Is Subaru OBD2?
When your Subaru has a problem, its On-Board Diagnostic (OBD) system will trigger a code so a technician can better identify the issue. If you have access to an OBD-II scanner, feel free to search our database so you can get a better idea what might be wrong with your vehicle.
What cars have OBD2?
1996 or newer model year vehicle sold in the United States
United States legislation requires all cars and light trucks model year (MY) 1996 and newer to be OBD2 compliant. More information is available on the EPA’s website.
How do I access OBD2?
It your vehicle may also have a cover that you’ll need to remove in order to get to it. But if the port’s not there check around or under the center console.
Where is the OBD2 port on a Subaru?
So you’ll be able to open up your driver’s door get down in here. And right down here at the bottom. Right there where your left foot would be. You can sit it on there.
