Location of OBD Fuse on a 2010 Toyota Tundra
The OBD (On-Board Diagnostics) fuse on a 2010 Toyota Tundra is located in the Drivers side junction block, near the driver’s left knee. It is a 7.5 Amp fuse that powers pin 16 on the DLC 3 (OBD Port).
If you have any other questions or need further assistance, feel free to ask!
Contents
- Where is the OBD on a truck?
- Why is my OBD2 port not communicating?
- What do I do if my OBD port is not working?
- Where is the diagnostic plug on a Toyota?
- What is the OBD port diagnostic?
- How do I reset my OBD2?
- Where is the fuse for the OBD2 port?
- Where is the OBD port on a 2010 Toyota Tundra?
- Where is the diagnostic plug?
- Why is my ob2 plug not working?
Where is the OBD on a truck?
Vehicle diagnostic ports can vary based on the vehicles make, engine type, VIN/Model year, and the date the trucks manufacturing was completed, or have diagnostic port replaced with aftermarket ports. Diagnostic ports are generally located below the steering wheel on the left side or behind the dashboard.
Why is my OBD2 port not communicating?
Check the condition of the pins, wiring, and connectors on the OBD2 port and the ECU. Look for any signs of corrosion, loose wires, or bent pins. Clean or replace them if needed. Test the fuses with a multimeter to see if they are working fine.
What do I do if my OBD port is not working?
Check the OBD-II port and fuses
If the multimeter shows 0 volts then check for a blown fuse – often the OBD-II is fused on the auxiliary circuit ((they’re usually still called “cigarette” on the fuse diagram panel). If OBD-II port and power receptacle fuse check out OK, then the cable or unit may need to be replaced.
Where is the diagnostic plug on a Toyota?
Locations: Under the drivers side dash panel. Locations: Near the left hand strut tower. Near the right hand strut tower. Next to the airflow meter or battery.
What is the OBD port diagnostic?
The OBD port is a standardised diagnostic interface that allows technicians to access information about a vehicle’s performance and health. It is typically located beneath the dashboard, near the driver’s seat.
How do I reset my OBD2?
Plug an OBD-II scanner into your vehicle’s OBD port and reset it to clear the check engine light. Disconnecting and reconnecting your battery will restart your vehicle’s computer and clear the light. Drive an older vehicle around for a few days after repairs. The light will go off on its own once the computer resets.
Where is the fuse for the OBD2 port?
Box. And hopefully this will get your OBD2 port to work. Okay thank you for watching this short video. I hope it was helpful and educational. If it was please like it.
Where is the OBD port on a 2010 Toyota Tundra?
The OBDII port is easy to find, just look under the dash on driver side and to the left.
Where is the diagnostic plug?
The OBD-II port is usually located under the dashboard, beneath the steering wheel column (1 – 3 in the diagram below). If not located beneath the steering column, look for the port in the areas indicated by numbers 4 – 9.
Why is my ob2 plug not working?
Check the OBD-II port and fuses
If the multimeter shows 0 volts then check for a blown fuse – often the OBD-II is fused on the auxiliary circuit ((they’re usually still called “cigarette” on the fuse diagram panel). If OBD-II port and power receptacle fuse check out OK, then the cable or unit may need to be replaced.
