Where is the heater control valve on a 2013 Ford Fusion?

Location of Heater Control Valve on a 2013 Ford Fusion
The heater control valve on a 2013 Ford Fusion is responsible for controlling the flow of engine coolant to the heater core, which is located within the passenger compartment. When the heater or defroster is turned on, warm engine coolant passes through the heater core, and a fan forces air across its surface and into the passenger compartment, providing warmth. During times when the air conditioner is in use, the heater control valve closes to prevent engine coolant from entering the heater core, resulting in less heat in the passenger compartment to allow the air conditioner to work more efficiently.
The heater control valve is typically located in the engine compartment, and it controls the flow of coolant from the engine to the heater core. It can be operated in three basic ways: through a manual cable, a thermostat type system, or even engine vacuum. It’s important to note that since the air and heating system is a closed system, a mechanic won’t typically check the heater control valve during routine inspections and services. Instead, it’s recommended to keep an eye on the air and heating system and schedule an inspection if any malfunction is noticed.
In summary, the heater control valve on a 2013 Ford Fusion is integral to the vehicle’s cooling system and is responsible for controlling the flow of engine coolant to the heater core located within the passenger compartment. It is typically located in the engine compartment and plays a crucial role in ensuring the proper functioning of the heating and AC system .

Where is the heater control valve located?

The heater control valve is typically in line with the heater core’s inlet hose, which is often near the vehicle’s firewall, but the exact location of the valve will vary by vehicle.

Where is the block heater cord on a 2013 Ford Fusion?

The block heater cord should be on the passenger side of the engine under the hood, its folded and clipped in place near the hood support pivot and above the radiator assembly. It doesn’t hang out of the engine bay very far at all.

What happens when control valve fails?

If it fails open, the engine will merely run cooler than designed, the only negative consequence being decreased efficiency. With this in mind, the only sensible choice for a control valve is one that fails open (air-to-close). However, our choices in instrument action do not end with the control valve.

Why is the heat not working on my Ford Fusion?

The most common reasons a Ford Fusion heater isn’t working are a broken heater blower motor, a problem with the thermostat, or a failed heater blower motor resistor.

Does Ford Fusion have block heater?

They are actually standard equipment on models that were originally developed to northern US states as well as Canada. Ours had one but never used it. We can get down to negative single-digits and never had an issue starting the car.

What is another name for the heater control valve?

The heater control valve (or hot water valve) opens to allow hot coolant from your engine to flow through the heater core.

How do I know if my heater control valve is bad?

Signs of a bad heater control valve

1. No heat coming out.
2. Heat always on and cannot be turned down.
3. Heat output changes with no changes in the heat setting.
4. Temperature gauge reads hot.
5. Low coolant level.
6. Coolant leak.

What happens when heater control valve is bad?

Your car’s heater won’t turn on.
A broken heater control valve may be more obvious in the winter, because it will often prevent the heater from coming on inside your car. If your car refuses to get warm, schedule repair services right away so you can stay safe and comfortable in colder weather.

Why is my car blowing but no heat?

If one or more of these issues is present, your vehicle may blow out cool air rather than heat: Not enough coolant in the engine. Problems with the heater core. Clogged or broken heating controls.

Where is the engine block heater on a Ford Fusion?

Re: Block Heater Location
your block heater cord should be on the passenger side of the engine under the hood, its folded and clipped in place. near the hood support pivot,above the radiator assembly.