Where is the headlight control module on a Ford Ranger?

Location of the Headlight Control Module on a Ford Ranger
The headlight control module on a Ford Ranger can be found in the fuse panel under the hood. It is important to note that the specific location may vary depending on the model year of the vehicle.
If you are experiencing issues with the headlight control module, it may be necessary to reset it. Depending on the year of your Ranger, you may be able to reset it by disconnecting the negative battery terminal and leaving the truck to sit for 10-15 minutes. For newer models, it is recommended to take the truck into a Ford service center for a reset using their proprietary tools.
In some cases, the headlight control module may need to be reloaded or recalibrated to address issues with the headlights. It’s also worth noting that the headlight control module is part of the body control module (BCM), which controls all the non-engine related functions and features of the vehicle.
If you require further assistance with the headlight control module or any related issues, it is advisable to consult a qualified technician or reach out to a Ford service center for professional support.
I hope this information helps! If you have any more questions or need further assistance, feel free to ask.

What does the headlight control module do?

Headlight control module used for providing an automatic high beam is beneficial for driving, especially on highways, as it automatically switches between high beam and low beam, based on the oncoming traffic from the opposite direction.

What is headlamp delay on Ford Ranger?

Set the delay time to keep the headlamps on for up to three minutes after switching off the ignition.

Does a headlight control module need to be programmed?

Yes it needs to be programmed since you installed different modules, the car does not know that.

What is Ford headlamp delay?

The headlamps will switch off automatically after three minutes with any door open or 30 seconds after the last door has been closed. You can cancel this feature by pulling the direction indicator toward you again or switching the ignition on.

Where is the light control module?

Although vehicles can differ, the Light Control Module is normally located underneath the steering wheel, above and to the right of the gas pedal.

Where is the Ford Ranger BCM located?

The BCM is located on the driver’s side of the vehicle underneath the dash panel.

How do I reset my Ford BCM?

Just remove both cables from the battery and touch the ends of the cables together to bleed off the voltage stored in the BCM capacitors, which resets the BCM’s memory and erases trash data. The original programming is non-volatile and will always remain.

How do I know if my headlight module is bad?

First starts to fail. But in most situations. These problems will only get worse over time eventually leading to the loss of the headlight. Function erratic pop-up headlight operation.

Why is my headlight module not working?

The likely cause is a fuse, headlight relay, headlight switch, dimmer switch or a wiring fault. About the only cause that is an easy fix is a blown fuse. Consult your owner’s manual to locate the main fuse for the headlight circuit and replace that fuse with one having the same amp rating.

How do you know if BCM module is bad?

Erratic Electrical Function A faulty body control module can also cause intermittent operation of various electrical functions, such as a vehicle’s horn, lights, and wipers. Wildly sweeping instrument cluster dials are also a tell-tale sign of body control module failure, as is irregular door lock and radio operation.