The fusible link on a 2008 Chevy Uplander is located at the under hood fuse block. It is shown as gray with a white stripe and turns into a red/black wire that carries power to the instrument panel fuse block. The fusible link most likely originates where the battery cable red wire connects to the under hood fuse block.
Location of the Fusible Link
The fusible link on a 2008 Chevy Uplander is located at the under hood fuse block.
I hope this helps! Let me know if you have any other questions.
Contents
- Does a 2008 Chevy Uplander have a fuel filter?
- Where is the body control module on a 2008 Chevy Uplander?
- How do you know if a fusible link is blown?
- Where is the fuel filter located on a Chevy Uplander?
- What does the BCM fuse control?
- Why won’t my 2008 Chevy Uplander start?
- What are the symptoms of a bad fusible link?
- Where are fusible links located?
- How do I tell if fuel filter was bad?
- What happens when body control module goes bad?
Does a 2008 Chevy Uplander have a fuel filter?
The 2008 Chevy uplander fuel filter is located inside the fuel tank and is an integral part of the fuel pump module assembly.
Where is the body control module on a 2008 Chevy Uplander?
HELLO LOOKING FOR BCM ON 08 UPLANDER
The BCM is located on the drivers side of the passenger compartment under the dashboard.
How do you know if a fusible link is blown?
You should perform a quick continuity. Check on the alternator fuse in your car. Stalling. In the worst case scenario a blown alternator fuse could cause a vehicle called to actually crash.
Where is the fuel filter located on a Chevy Uplander?
Where is the fuel filter located on my Chevrolet? The fuel filter is always going to be found between the fuel tank and the engine. For most vehicles, the fuel filter is located inside the top of the fuel tank, right where it connects with the fuel line, although on some cars if might be elsewhere along the fuel line.
What does the BCM fuse control?
The Body Control Module is a generic term for an electronic control unit, responsible for monitoring and controlling various electronic accessories in a vehicle’s body. Typically, in a car, the BCM controls the power windows, power mirrors, air conditioning, immobilizer system, central locking, etc.
Why won’t my 2008 Chevy Uplander start?
The most common reasons a Chevrolet Uplander won’t start are a dead battery, an alternator problem, or failed starter.
What are the symptoms of a bad fusible link?
Unexpectedly. You may also notice the check engine light coming on for questionable. Reasons and all sorts of erroneous trouble codes stored as a result of bad fusible.
Where are fusible links located?
It is usually located in a wiring harness near a main harness connection; the fusible link may have a current capacity tag attached. There have been reports that fusible links have initiated fires.
How do I tell if fuel filter was bad?
Here are five of the bad fuel filter symptoms to watch for:
- You have a hard time starting car. If the problem is the fuel filter, and it isn’t changed soon, you may find that your vehicle won’t start at all.
- Misfire or rough idle.
- Vehicle stalling.
- Fuel system component failure.
- Loud noises from the fuel pump.
What happens when body control module goes bad?
A faulty BCM can trigger various issues such as malfunctioning electronics, excess battery drain, and a no-start condition.
