AHG Auto Service » Make » Ford » Where is the fuse on a 1963 Ford Falcon?

Where is the fuse on a 1963 Ford Falcon?

Location of the Fuse on a 1963 Ford Falcon
The fuse box on a 1963 Ford Falcon is located behind the dashboard. To access the fuse box, you will need to follow these steps:
1. Disconnect the Battery: It’s important to disconnect the battery before proceeding to work on the fuse box.
2. Remove the Headlight Switch: Pull the headlight switch as if you want to put the headlights on. Press the small button underneath the fuse box behind the headlight switch and the switch will come out of the socket. The fuse box will drop from the dashboard just enough to see the fuses.
3. Locate the Fuses: Once the fuse box is accessible, you can replace the fuses for the turn signals, heater fan, and fuel gauge. The fuses will be labeled, or you can refer to the owner’s manual for their locations. There are probably two fuses: SFE 7.5 and SFE 14.
It’s important to note that accessing the fuse box on a 1963 Ford Falcon may require some effort, but following these steps should allow you to locate and replace the fuses as needed.

How do I know which fuse?

They come in various sizes and shapes and have an amperage rating written at the top. To determine the type of blade fuses your vehicle uses, check your owner’s manual for a fuse box diagram. A fuse box diagram will show you what kind of fuse goes into each slot and the exact amperage to use.

How much horsepower does a 1963 Ford Falcon have?

The V-8 had 260 cubic inches and 164 horsepower. The new V-8 was available not only in Sprints, but also available in other 63 ½ Falcon models.

Where is the Ford fuse box?

And right behind the battery this will be on the passenger. Side it’ll be this box right behind here and it should have a sign there that shows you a fuse.

Where is the secondary fuse box?

The secondary under-hood fuse box is next to the battery. To open it, push the tabs as shown. If something electrical in your vehicle stops working, check for a blown fuse first. Determine from the chart on pages and , or the diagram on the fuse box lid, which fuse or fuses control that device.

What engine is in a 1963 Ford Falcon?

First generation (1960–1963)

First generation
Powertrain
Engine 144 cu in (2.4 L) Mileage Maker inline six-cylinder (I6) 170 cu in (2.8 L) Mileage Maker I6 260 cu in (4.3 L) Challenger V8 (after 1962)
Transmission 2-speed automatic 3-speed manual 4-speed manual
Dimensions

Where is blown fuse located?

You can usually spot blown fuses by locating a discolored fuse or a melted piece of metal. If your fuse box is labeled, you may be able to narrow down the fuses based on what part of your home lost power. Remove the blown fuse.

Where is the engine compartment fuse block?

Engine fuse boxes are typically situated near the battery. In this vehicle, the battery is on the driver’s side, and there is a fuse box right above it with a black plastic cover to protect the fuses.

How do you open a Ford fuse box?

At the bottom right hand corner of the side of the fuse box is a “tab” or “latch” that you need to pull out and the door will then swing open.

How many miles per gallon does a 1963 Ford Falcon get?

Based on data from 5 vehicles, 23 fuel-ups and 3,218 miles of driving, the 1963 Ford Falcon gets a combined Avg MPG of 18.10 with a 1.69 MPG margin of error.

Where are the fuses located?

Look for the fuse box in closets, hallways, mudrooms, crawl spaces, basements, utility rooms, or laundry rooms. Fuse boxes in more prominent locations might be covered with a wood panel or picture meant to disguise the appearance of the box cover or door.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment