Location of the Fuel Pump Module on a 2007 Ford Explorer Sport Trac
The fuel pump module on a 2007 Ford Explorer Sport Trac is typically located under the truck, near the fuel tank. It is a small, black box with a wiring connector. The exact location can vary depending on the specific model and trim level of your vehicle. It may be accessed by removing the rear seat, the carpeting, or a panel in the cargo area.
Please note that it is important to disconnect the battery before working on the fuel pump module for safety reasons.
I hope this helps! Let me know if you have any other questions.
Contents
- How long does it take to replace a fuel pump module?
- Is a fuel pump and fuel pump module the same thing?
- Will a bad fuel pump control module cause no start?
- What possible type of code would you check for a fuel pump module issue?
- What happens when fuel pump module goes out?
- Where is the fuel pump control module location?
- How do I know if my fuel pump control module is bad?
- What does a Ford fuel pump module do?
- Can you drive with a bad fuel pump control module?
- What is the code for a bad fuel pump module?
How long does it take to replace a fuel pump module?
How long does it take to replace a fuel pump? In most cases, around two to three hours. However, job times can vary widely depending on how easy it is to access the pump. The fuel pump sits inside the fuel tank, and is attached to a plate on the top of the tank.
Is a fuel pump and fuel pump module the same thing?
A fuel pump and a fuel pump module are both components of a vehicle’s fuel delivery system, but they serve different functions.
Will a bad fuel pump control module cause no start?
Hi again. Not if the module is completely failed it will not run. But not all failures would knock the module out completely.
What possible type of code would you check for a fuel pump module issue?
The P069E code indicates that the module responsible for keeping the fuel pump working has encountered a problem.
What happens when fuel pump module goes out?
When the driver module malfunctions, the pump won’t produce the right amount of pressure, causing the engine to run low or misfire. Your engine can also stall because of it.
Where is the fuel pump control module location?
Depending on your application, the fuel pump driver module is either located on the rear Crossrail above the spare tire or on the rear frame wall.
How do I know if my fuel pump control module is bad?
Common Failure Symptoms
- No start.
- Rough idle.
- Loss of power.
- Hesitant acceleration.
- Intermittent engine performance.
What does a Ford fuel pump module do?
And controls the voltage applied to the fuel pump in the tank. Generating the necessary. Pressure. The reason some ford vehicles have failures. However is the placement of these units on the vehicle.
Can you drive with a bad fuel pump control module?
Depends on how bad the pump is if it is totally shot the answer is NO. If the pump is weak but still able to get fuel up to the engine then maybe, however you most likely will be on the side of the road waiting for the tow truck.
What is the code for a bad fuel pump module?
P069E
Code P069E indicates the FPCM has detected a problem with the fuel system and has sent a request to the ECM to turn on the check engine light. The check engine light is also known as the malfunction indicator lamp (MIL). A vehicle with this code should be taken in to a repair shop for diagnosis.
