AHG Auto Service » Make » Toyota » Where is the fuel pump control module on a Toyota Tundra?

Where is the fuel pump control module on a Toyota Tundra?

The fuel pump control module on a Toyota Tundra is located inside the fuel pump, which is inside the fuel tank. To access it, you would need to jack up the Tundra and safely place it on jack stands before proceeding underneath the vehicle. Always remember to take necessary safety precautions when dealing with both the electrical system and the fuel system.

Where is the fuel pump control module on a 2016 Toyota Tundra?

THE FUEL PUMP MODULE WILL BE ON THE INSIDE FRAME RAIL BEHIND THE TANK ON THE DRIVERS SIDE.

What are the symptoms of a bad fuel pump control module?

Common Failure Symptoms

  • No start.
  • Rough idle.
  • Loss of power.
  • Hesitant acceleration.
  • Intermittent engine performance.

Can you clean a fuel pump module?

If your vehicle has an electric fuel pump, you can use a fuel system cleaner to clear any sediment buildup or blockage. If you have a manual one (usually found in older model vehicles), you can actually open the pump to clear debris out of its internal filter, though that isn’t an option in most modern vehicles.

How much does it cost to replace a fuel pump control module?

How Much Does a Fuel Pump Driver Module Replacement Cost? The cost of an aftermarket fuel pump driver module replacement can range between $100 to $550 for parts alone. Several factors affect pricing, such as brand and warranty. Labor can cost you an additional $125 to $300, depending on the rates in your area.

What happens when fuel pump module goes out?

And symptoms we discuss boil down to a lack of fuel flow. And that’s really the biggest thing that that tends to occur when you do have a fuel pump failure is that it just start sending too little

Where is the fuel pump control module on a 2007 Toyota Tundra?

The fuel pump control module on a 2007 Toyota Tundra is located inside the fuel pump which is inside the fuel tank. The pump creates higher pressure in the fuel lines, pushing the gasoline to the engine. The higher pressure raises the boiling point of the gasoline.

How do you know if you need a fuel pump module?

Signs Your Fuel Pump is Going Bad
Whining noise coming from the fuel tank area when the engine is running. Stalling that will restart after several minutes. Trouble starting the car. Lack of power.

How long does it take to replace a fuel pump module?

How long does it take to replace a fuel pump? In most cases, around two to three hours. However, job times can vary widely depending on how easy it is to access the pump. The fuel pump sits inside the fuel tank, and is attached to a plate on the top of the tank.

Can a bad ECM cause fuel pump failure?

To answer the question, the fuel pump relay is triggered by the ECM, if there is no communication with the ECM, the ECM will not activate the fuel pump relay, so it won’t turn on. Possible cause for the U0100 faults : Faulty ECM.

Where is fuel pump control module located?

Depending on your application, the fuel pump driver module is either located on the rear Crossrail above the spare tire or on the rear frame wall.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment