The fuel pump control module on a Subaru is typically located in the trunk, specifically on the passenger side . It regulates the operation of the fuel pump by controlling the voltage and speed at which the fuel pump operates [[8]]. The fuel pump control module is responsible for ensuring that the fuel pump provides the engine with the appropriate amount of fuel .
Contents
- What is the code for a bad fuel pump module?
- How do I know if my fuel module is bad?
- What happens when a fuel pump control module goes bad?
- How do I know if my fuel sending unit is bad?
- How long does it take to replace a fuel pump module?
- Where is the fuel pump control module location?
- What is the difference between a fuel pump and a fuel pump module?
- Will a bad fuel pump driver module throw a code?
- How do you know if your control module is bad?
- How much does it cost to replace a fuel pump control module?
What is the code for a bad fuel pump module?
P069E
Code P069E indicates the FPCM has detected a problem with the fuel system and has sent a request to the ECM to turn on the check engine light. The check engine light is also known as the malfunction indicator lamp (MIL). A vehicle with this code should be taken in to a repair shop for diagnosis.
How do I know if my fuel module is bad?
For most cars the fuel pump will be located. Inside the gas tank. The first symptom of a bad fuel pump is having your check engine light on you might get a p00. Or a p0190. Both having to do with lack
What happens when a fuel pump control module goes bad?
When the driver module malfunctions, the pump won’t produce the right amount of pressure, causing the engine to run low or misfire. Your engine can also stall because of it.
How do I know if my fuel sending unit is bad?
Here are some signs that the fuel sending unit is bad and some speculations on how and why the fuel sending unit failed.
- Fuel gauge reading empty when the tank is full.
- Fuel gauge is stuck on full.
- Fuel gauge fluctuates between empty and full.
How long does it take to replace a fuel pump module?
How long does it take to replace a fuel pump? In most cases, around two to three hours. However, job times can vary widely depending on how easy it is to access the pump. The fuel pump sits inside the fuel tank, and is attached to a plate on the top of the tank.
Where is the fuel pump control module location?
Depending on your application, the fuel pump driver module is either located on the rear Crossrail above the spare tire or on the rear frame wall.
What is the difference between a fuel pump and a fuel pump module?
The Fuel Pump Driver Module controls the voltage delivered to a vehicle’s fuel pump. By controlling the voltage, the module maintains optimal fuel pressure and fuel delivery to the engine throughout its full operating range.
Will a bad fuel pump driver module throw a code?
A bad fuel pump will cause a lean condition, so yes, a code will eventually be thrown.
How do you know if your control module is bad?
Some symptoms of a bad ECM include an illuminated check engine light, no start condition, poor engine performance, and an ECM that refuses to run emissions monitors. Usually, only a part of the ECM becomes compromised.
How much does it cost to replace a fuel pump control module?
How Much Does a Fuel Pump Driver Module Replacement Cost? The cost of an aftermarket fuel pump driver module replacement can range between $100 to $550 for parts alone. Several factors affect pricing, such as brand and warranty. Labor can cost you an additional $125 to $300, depending on the rates in your area.
