AHG Auto Service » Make » Lexus » Where is the fuel pump control module on a Lexus GS 300?

Where is the fuel pump control module on a Lexus GS 300?

Location of the Fuel Pump Control Module on a Lexus GS 300
The fuel pump control module on a Lexus GS 300 is located in the left rear of the trunk. It is powered by the EFI fuse in the engine compartment main fuse box and is computer-controlled. If you are experiencing issues with your fuel pump, it is recommended to have a mechanic diagnose the problem.
Please note that the information provided is based on the search results and may vary depending on the specific model and year of the Lexus GS 300. It is always best to consult the vehicle’s manual or seek professional assistance for accurate and specific information.

How do I know if my fuel pump control module is bad?

Common Failure Symptoms

  1. No start.
  2. Rough idle.
  3. Loss of power.
  4. Hesitant acceleration.
  5. Intermittent engine performance.

Where is the fuel pump control module on a Lexus gs300?

Which is held in by three 10 millimeter plastic. Nuts. Doing this exposes the fuel pump connector. And the fuel feed line remove the connector by pushing in the plastic Tab and pulling it out.

Where is the fuel pump relay on a Lexus rx300?

The EFI relay is located under the hood and the citcuit opening relay is located under the drivers side dash. Both provide power to the fuel pump.

Where is the fuel pump control module on a 2000 Lexus gs300?

The fuel pump module/ecu is located in left rear of luggage compartment.

What is the part number of the fuel pump on a gs300?

2322131340
Lexus GS 300 Pump, fuel – 2322131340 – Genuine Lexus Part.

Where is the fuel pump module located at?

More often than not, the fuel pump driver module (FPDM) is located in the back of vehicles. The exact location varies depending on the make and model of your ride, but it’s usually on the underside — specifically on the rear end of the frame. The fuel pump driver module controls the power allocated to the fuel pump.

What happens when a fuel pump control module goes bad?

When the driver module malfunctions, the pump won’t produce the right amount of pressure, causing the engine to run low or misfire. Your engine can also stall because of it.

How can I tell if my fuel pump relay is bad?

Since the relay isn’t closing like it should the pump can’t build up standard fuel system. Pressure. No pressure means cranking the starter has to overcome that lack of initial fuel as.

Where is the fuel pump fuse on a gs300?

Take a look along the front of the bay, in the area in front of the battery. There, You will find the fuse box. Inside is an array of fuses and switches. Using the sticker on the lid of the black fuse box, match the code to the fuel pump relay inside.

Where is the fuel pump control module location?

Depending on your application, the fuel pump driver module is either located on the rear Crossrail above the spare tire or on the rear frame wall.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment