AHG Auto Service » Make » Chevrolet » Where is the engine coolant temperature sensor on a 2018 Chevy Trax?

Where is the engine coolant temperature sensor on a 2018 Chevy Trax?

Location of the Engine Coolant Temperature Sensor on a 2018 Chevy Trax
The location of the engine coolant temperature sensor in a 2018 Chevy Trax may vary depending on the specific system you are referring to. The Chevy Trax has multiple temperature sensors for various systems. Here are a few possible locations of temperature sensors in the Chevy Trax:
1. Engine coolant temperature sensor: The engine coolant temperature sensor is typically located near the engine coolant outlet or thermostat housing. It is responsible for monitoring the temperature of the engine coolant.
2. Other temperature sensors: The Chevy Trax may also have temperature sensors for other systems, such as the ambient air temperature sensor. The location of these sensors may vary.
It is recommended to consult the vehicle’s manual or seek professional assistance for the exact location of the engine coolant temperature sensor in a 2018 Chevy Trax.
Please note that the information provided is based on general knowledge and may not be specific to every individual vehicle. It is always best to refer to the vehicle’s manual or consult a professional for accurate information.
Let me know if there’s anything else I can help with!

How do I know if my coolant temp sensor is bad?

4 Signs Your Coolant Temperature Sensor is Faulty

  1. Faulty Coolant Temperature Sensor – 4 Common Symptoms.
  2. Fuel Consumption Increases.
  3. Check Engine Light Flashes.
  4. Engine Overheating.
  5. Black Smoke from the Exhaust.
  6. Don’t Ignore the Warning Signs.
  7. Reliable Car Maintenance with Professional Auto Experts!

What happens when the coolant temperature sensor goes out?

A malfunctioning coolant temperature sensor may send an incorrect “cold” signal to the ECU, tricking it into believing the engine isn’t hot yet. The ECU will then adjust the fuel injection, ignition timing, and variable valve timing, further raising the engine’s temperature and causing it to overheat.

How long does it take to replace a coolant temperature sensor?

How long does it take to replace a coolant sensor? In most cases, it is 5 to 10 minutes, once you have the right wrench in your hand and the sensor in the other.

Where is the temperature sensor on a 2017 Chevy Trax?

Engine coolant temperature sensor – The engine coolant temperature sensor on the Chevy Trax is typically located on or near the engine block. It may be located near the thermostat housing or in the cylinder head.

How much does it cost to replace a coolant temperature sensor?

What Does It Cost to Replace an ECT Sensor? If your ECT sensor needs to be replaced, it will typically cost between $200 and $400. This includes the cost of labor, which is usually between $100 and $150, and the cost of parts, which is usually between $5 and $250.

Can you replace a coolant sensor yourself?

Using a wrench, unscrew the coolant temperature sensor from the coolant passage. A ratcheting wrench can be a big time saver in tight spaces. Insert the new sensor. Torque to spec listed in your repair manual, usually under 20 lb-ft.

Are there 2 coolant temperature sensors?

There are two temperature sensors in some vehicles, one to send information from the engine system to the control unit and another from the control unit to the dashboard. The device follows the principle of dependence of potential difference in temperature.

Is it hard to replace coolant temperature sensor?

Yes, it’s extremely easy but also very dangerous. It is shaped like a big bolt and simply unscrews from the socket. But if this is done when the vehicle is hot it will spray out boiling coolant. So the vehicle must be allowed to sit and cool down with the radiator cap off before changing the sensor.

Where is the coolant temperature sensor located?

Where is the Coolant Temperature Sensor located? The coolant temperature sensor will be located directly behind the coolant pipe. In most modern cars and vehicles, this is present behind the right cylinder head that is located right underneath the air intake pipe.

Will a bad coolant sensor throw a code?

In most cases, a bad coolant temperature sensor will throw a Check Engine Light and produce a trouble code indicating the temp sensor is bad.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment