AHG Auto Service » Make » Dodge » Where is the EGR valve located on a 05 Dodge Ram 1500?

Where is the EGR valve located on a 05 Dodge Ram 1500?

EGR Valve Location on a 2005 Dodge Ram 1500
The EGR (exhaust gas recirculation) valve on a 2005 Dodge Ram 1500 with a 4.7L engine is located on the rear of the driver’s side head. Here are the specific steps to locate it:
– The EGR valve is attached to the rear of the left cylinder head, and an exhaust gas routing tube connects the EGR valve to the intake manifold.
To find the EGR valve, you can follow these steps:
1. Look at the left side of the plastic intake manifold, a bit to the rear of the throttle body.
2. You will find a metal tube coming off, making a 90-degree bend to the rear. Follow this tube to the rear of the left head, and you’ll find the EGR valve.
It’s important to note that accessing and replacing the EGR valve may be challenging due to its location.
If you have any further questions or need additional assistance, feel free to ask!

How do I locate my EGR valve?

The EGR valve is usually on a pipe that connects the exhaust manifold or intake manifold. The valve is typically at the top of the engine’s rear near the firewall on vehicles with a carburetor. To access the valve, you must disconnect the car battery’s negative terminal.

Where is the EGR valve located on a 2005 Dodge Ram 1500?

The EGR valve is located on the front of the cylinder head on the passenger side just below the alternator. Pull out the red safety tab on the connector.

Can I drive with faulty EGR valve?

If your vehicle has a faulty EGR valve, it might still be safe to drive for a short period, especially if the issue doesn’t significantly impact performance or safety. However, driving with a malfunctioning EGR valve can potentially affect your vehicle’s emissions, performance, and fuel efficiency over the long run.

Does 2005 Dodge Ram have EGR?

The electronic EGR valve and solenoid assembly is attached to the rear of the left cylinder head. An exhaust gas routing tube connects the EGR valve to the intake manifold.

How do you tell if your EGR valve needs to be cleaned or replaced?

When Do You Know It is Time to Clean?

  1. Difficulty in starting the engine.
  2. Rough idle.
  3. Engine vibration.
  4. Poor acceleration of the engine (during drive)
  5. Engine easily running hot.
  6. Engine ‘ping’ when under load.
  7. Smell of unburned gas fumes.
  8. Decrease in gas mileage.

Where is the EGR valve on a 5.7 Hemi?

So you go over on your passenger side locate your alternator. And then straight down from there off to the left you’ll see it. So this here is that. There is your EGR valve.

What happens if EGR valve is stuck closed?

If the exhaust gases don’t come in the temperature. Inside the chamber will increase and produce more knocks. And too much knox will fail your emissions.

Can you still drive with a bad EGR valve?

Technically you can drive without a working EGR valve.
The role of your EGR valve is to reduce the number of toxic NOx gases in the air, so if it isn’t working quite right, more toxic gases will be released into the air. For this reason, we don’t recommend driving without a working EGR valve for too long.

What are the symptoms of a clogged EGR valve?

A malfunctioning EGR valve can lead to a noticeable decline in engine performance. You may experience a rough idle, hesitation, or stalling when starting your vehicle. Acceleration may feel sluggish, or you may notice a lack of power when driving uphill. Increased fuel consumption.

Where can I find my EGR valve?

So you know it’s on the top of the engine. This is going to be on the driver’s. Side and this is going to be on the driver’s side in the rear of the engine.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment