Where is the drain plug on a Honda Pilot?

Location of Drain Plug on Honda Pilot
The drain plug for the oil on a Honda Pilot is typically located on the oil pan at the bottom of the engine. It is used to drain the engine oil during an oil change. The specific location may vary slightly depending on the model year and whether the vehicle has all-wheel drive or two-wheel drive. For example, for a 2017 Ridgeline, the drain plug is accessed by removing the right front wheel to get to the block drain plug. It will look like an oversized zerk, and a hose can be attached to the nipple to drain the oil.
For the coolant, the drain plug is located on the engine block. The service manual mentions attaching a hose to the drain bolt in the engine block to drain the coolant. However, locating the drain plug in real life may require removing the splash shield to access it. It is important to consult the vehicle’s service manual for specific instructions and to ensure proper maintenance of the cooling system.
In summary, the oil drain plug is located on the oil pan at the bottom of the engine, while the coolant drain plug is located on the engine block, which may require removing the splash shield for access.
If you need further assistance with locating the drain plugs or performing maintenance on your Honda Pilot, it is recommended to refer to the vehicle’s service manual or consult a qualified mechanic for guidance.

Where is the drain plug located?

You should be able to see and reach a large nut or plug located under the oil pan at the bottom of the engine (see Figure 13-6). This is the oil drain plug. It unscrews with the aid of an adjustable wrench. If the plug is too hot to touch comfortably, let the engine cool off for a while longer.

Where is the oil drain in my car?

The drain plug is a large nut or plug located under the oil pan at the bottom of the engine. If you can’t reach your oil drain plug easily, you’ll have to either crawl under your car to reach it or jack up the car.

What size is the oil drain plug on a Honda Pilot?

Dorman – Pilot Point Engine Oil Drain Plug: M14-1.50 Thread, 16 mm Head, 1 Pack (Part No. 090-053CD)

What size socket is the oil drain plug?

What size wrench to use for an oil drain plug depends on the size of the oil drain plug itself, which is a long bolt head. There is no universal oil plug size, but they do come in just a few several standard sizes, such as ¼ inch (. 6 centimeters), 3/8 inch (. 9 centimeters), ½ inch (1.3 centimeters), etc.

How do you drain the oil out of a Honda Pilot?

Run the engine until it reaches normal operating temperature, and then turn the engine off. Open the hood and remove the engine oil fill cap. Remove the drain bolt and washer from the bottom of the engine, and drain the oil into a suitable container.

What size socket do I need to remove the oil?

Place a 3/8-inch (0.9 centimeters) socket in the socket wrench, fit it over the drain plug’s nut and turn it counterclockwise. The oil drain plug should open easily, draining the used oil from the engine. Make sure to place a bucket and some newspaper under the car’s engine to catch all the draining oil.

Where is the drain oil drain?

Look under the car and locate the drain plug: It is a large nut or plug located under the oil pan (large tank) at the bottom of the engine.

Where do you drain oil from?

Warm up the engine for a few minutes, then turn it off and let it cool down. This will make the oil flow easier and faster. Locate the drain plug under the engine. It is usually a bolt or nut on the bottom of a large tank called the oil pan.

What size is the drain plug on a 2017 Honda Pilot?

Length: 1.71 in. Hex Size: 0.5 in.

How often do you need to replace a drain plug?

More manufacturers are choosing to use a copper washer or gasket that deforms when you tighten the drain plug. These copper washers are not designed to be reused, and they should be replaced at every oil change.