The drain plug on a 2001 Chevy Blazer radiator is located on the bottom left side of the radiator, if you’re looking at the car. To access it, you will need to use a 1/4 square key to turn the drain plug. Please note that it may be a bit difficult to reach, so you may need a universal joint to help with the access.
I hope this information helps! Let me know if you have any other questions.
Contents
- Where is the drain petcock on a radiator?
- How do I find my radiator drain valve?
- How do you unclog a coolant drain?
- Where is my radiator drain valve?
- Is there a drain plug on radiators?
- How do you drain water out of a radiator?
- How do you completely drain coolant from an engine?
- Where is the coolant drain plug?
- How do you drain the coolant on a 2001 Chevy Blazer?
- How do you drain coolant without a drain plug?
Where is the drain petcock on a radiator?
Well you climb down underneath here. And you might have a nice little drain underneath here at the bottom of the radiator or petcock. Something that’ll make it super easy to drain your radiator.
How do I find my radiator drain valve?
One radiator in your house will have a drain-off valve on the bottom left or right corner. Once you have located the valve, attach a hosepipe to the valve using clips. The other end of the attached hosepipe should be in a bucket or outside.
How do you unclog a coolant drain?
Drain the coolant from your radiator by opening the drain valve on the bottom of your radiator. Next, drain the coolant from your engine block by opening the block drain also. Add the purchased radiator flush to the radiator and let the car run. Drain like the old coolant, and suddenly your car is clean and fresh.
Where is my radiator drain valve?
3 Find the radiator with the drain-off valve
This is usually on the lowest point of all the radiators or pipework. Usually, the draincock can be found close to the ground floor radiators. When you have located the draincock, attach a hosepipe to it, using a jubilee clip to secure it, and drain the water outside.
Is there a drain plug on radiators?
The radiator drain plug is used to keep the radiator fluid inside, as well as draining the fluid when flushing the radiator.
How do you drain water out of a radiator?
Be careful not to unscrew it too far or it may pour out too fast. You don’t want this stuff on the ground let it drain fully then replace the drain plug.
How do you completely drain coolant from an engine?
And loosen the drain plug. This will typically be on the left or right side of the radiator. At the bottom allow the coolant to drain. Next move your catch pan underneath the engine.
Where is the coolant drain plug?
Locate the drain plug. This is found on the bottom of the radiator. Place a pan under the drain plug to catch old coolant. Loosen the drain plug and allow coolant to flow.
How do you drain the coolant on a 2001 Chevy Blazer?
2001 chevy blazer,v6 vortec needs radiator flush how do i drain the system? Drain the existing anti-freeze and coolant. Open the radiator and engine drain petcocks (located near the bottom of the radiator and engine block, respectively), or disconnect the bottom radiator hose at the radiator outlet.
How do you drain coolant without a drain plug?
In general, the easiest way to drain coolant from systems like these is to disconnect the lowest fitting between the coolant hose and the engine block and let the coolant just drain out. Usually, it’s near the bottom of the block itself, so it shouldn’t be hard to reach from underneath the vehicle.
