Where is the coolant temperature sensor on a 2010 Dodge Avenger?

Coolant Temperature Sensor Location on a 2010 Dodge Avenger
The coolant temperature sensor on a 2010 Dodge Avenger is located in two possible locations. The first one can be found mounted inside the top portion of the thermostat housing unit. The second sensor can be found beneath the intake manifold and engine. If either sensor proves to be faulty, they will need to be replaced. The cost for a new sensor is between $40 and $80, and if replaced by a mechanic, the labor cost is between $120 and $240.
If you need to replace the coolant temperature sensor, it’s important to note that the sensor is located in either the top portion of the thermostat housing unit or beneath the intake manifold and engine. It’s advisable to consult a professional mechanic for the replacement to ensure it is done correctly and efficiently.

Are there 2 coolant temperature sensors?

There are two temperature sensors in some vehicles, one to send information from the engine system to the control unit and another from the control unit to the dashboard. The device follows the principle of dependence of potential difference in temperature.

Does the coolant temp sensor control the thermostat?

No, the thermostat works off the heat of the water passing through it. A coolant temperature sensor might control the electric cooling fans though.

Can you drive with a bad coolant temp sensor?

If your coolant temperature sensor is failing or has failed, do not continue driving your vehicle. You should get it fixed right away. A faulty sensor can lead to overheating. This will cause damage to your engine as well as other components, which will be very expensive to fix.

What code does a bad engine coolant temp sensor throw?

The P0117 code indicates a problem with one of the engine coolant temperature sensors in your vehicle. Find out more about this error code and what to do in case you encounter it using this short guide.

What happens when coolant temperature sensor goes bad?

Here’s what happens: Faulty readings from the coolant temperature sensor can cause the engine to miscalculate the air-fuel mix in the engine. Any time the air-fuel mix ratio is not in proportion, and if the fuel mixture becomes too rich, the fuel will not be able to burn up inside the combustion chamber.

What is the symptoms of a bad temp sensor?

Your car’s coolant temperature sensor helps its ECU decide the fuel-air mixture ratio for combustion. A bad sensor may result in a rich fuel-air mixture, leading to black smoke from the exhaust pipe and poor fuel economy.

What are the symptoms of a bad coolant level sensor?

A faulty coolant level sensor can trigger the warning light and keep it on, even if the engine has enough coolant fluid. You might refill the coolant reservoir prematurely, leading it to overflow. If you ignore the perpetually lit coolant light, you might not notice when your vehicle is low on fluid.

How do I know if my temperature sensor or thermostat is bad?

What Are The Symptoms of a Faulty Temperature Sensor?

1. The equipment is experiencing intermittent thermocouple failure.
2. Instruments are showing “Open Circuit”.
3. The temperature gauge on your equipment isn’t reading accurately.
4. The equipment stops heating or cooling properly.
5. The equipment is overheating.

Where are coolant temp sensors located?

Where is the Coolant Temperature Sensor located? The coolant temperature sensor will be located directly behind the coolant pipe. In most modern cars and vehicles, this is present behind the right cylinder head that is located right underneath the air intake pipe.

How do I know if my coolant temp sensor is bad?

If the coolant temperature sensor is reporting the incorrect. Data to the computer. It can cause the computer to spray more fuel than it should one thing driver is going to know it’s going to be poor