Where is the coolant sensor on a 2014 Dodge Durango?

Location of Coolant Sensor on a 2014 Dodge Durango
The location of the coolant sensor on a 2014 Dodge Durango depends on the engine size. Here are the locations for two different engine options:
– 5.7L V8 Engine: The engine coolant temperature (ECT) sensor is located on the upper portion of the water pump housing. It is installed into a water jacket inline with the thermostat.
– 3.6L V6 Engine: The ECT sensor on the 3.6L engine is installed into a water jacket at the rear of the cylinder head on the left side of the engine. It is important to note that the cooling system must be partially drained before removing the coolant temperature sensor.
Please make sure to consult the appropriate source for your specific engine type to ensure accurate information.
I hope this helps! Let me know if you have any other questions.

Where is the coolant temperature sensor located?

Where is the Coolant Temperature Sensor located? The coolant temperature sensor will be located directly behind the coolant pipe. In most modern cars and vehicles, this is present behind the right cylinder head that is located right underneath the air intake pipe.

How do you reset a coolant temperature sensor?

And keep pressing for five to ten seconds. And then release it your ambient temperature sensor will reset. I hope this will fix your problem.

Is coolant temperature sensor easy to replace?

Replacing a coolant temperature sensor is a fairly manageable task for a DIY mechanic. Here are some general tips and tricks that you should take note of when it comes to engine coolant temperature (ECT) sensor replacement. Note: Make sure you know where the sensor is before you start.

Can you drive with a bad coolant sensor?

If your coolant temperature sensor is failing or has failed, do not continue driving your vehicle. You should get it fixed right away. A faulty sensor can lead to overheating. This will cause damage to your engine as well as other components, which will be very expensive to fix.

Where is the coolant temperature sensor located on a 2014 Dodge Durango?

The ECT sensor is located on the upper portion of the water pump housing. It is installed into a water jacket inline with the thermostat.

What are the symptoms of a bad coolant sensor?

• Fuel economy is poor. Poor fuel economy is one of the first signs of a problem with the coolant temperature sensor.
• The engine is spewing black smoke.
• Engine is overheating.
• The Check Engine Light illuminates.

Are there 2 coolant temperature sensors?

There are two temperature sensors in some vehicles, one to send information from the engine system to the control unit and another from the control unit to the dashboard. The device follows the principle of dependence of potential difference in temperature.

Can you replace a coolant temperature sensor?

If the temperature sensor is confirmed to be faulty, replacement of the sensor is typically easy for the moderately experienced DIYer. If knowledge of the engine cooling system and diagnosing cooling issues are lacking, this repair should be handed to a certified technician.

Can I drive with a bad coolant level sensor?

While a bad sensor won’t cause major issues, it can’t warn you about the engine potentially running low on coolant fluid. Therefore, you should replace it as soon as possible.

Does the coolant temp sensor control the thermostat?

No, the thermostat works off the heat of the water passing through it. A coolant temperature sensor might control the electric cooling fans though.