Location of the Blower Motor Resistor on a 2000 Dodge Dakota
The blower motor resistor on a 2000 Dodge Dakota is located under the center of the dash against the firewall. It is not necessary to completely remove the dash to access it, but the dash does need to be tilted back in the brackets by about 6 inches. The process of disassembling, exchanging the part, and reassembling can take at least 2 hours of labor.
Please note that the location of the blower motor resistor may vary depending on the specific model and year of the vehicle. It is always recommended to consult the vehicle’s service manual or seek professional assistance for accurate information.
I hope this helps! Let me know if you have any other questions.
Contents
- Where is my blower motor resistor located?
- Is the blower motor resistor part of the blower motor?
- Why is the heater not working in my 2000 Dodge Dakota?
- Where is the blower motor reset button?
- Where is the blower motor located on a Dodge Dakota?
- What happens when the blower motor resistor goes out?
- Does the blower motor control the fan?
- How do you remove a resistor from a blower motor?
- How do I know if my blower motor resistor is bad?
- Why is my Dodge Dakota AC not blowing?
Where is my blower motor resistor located?
Now these blower motor resistors are right next to the blower motor and the blower motor is commonly found either underneath the dash here on the passenger side sometimes you could open up your glove
Is the blower motor resistor part of the blower motor?
The blower motor resistor is responsible for controlling the blower motor speed. In the past, this was done by varying the voltage supplied to the blower motor. In newer applications, the blower motor resistor is actually a solid state module that sends a varied signal to the blower motor.
Why is the heater not working in my 2000 Dodge Dakota?
As the interior’s heating relies on the engine’s cooling system, checking the level of your coolant is the easiest place to start as a low coolant level may prevent coolant from reaching the heater core, and dirty coolant may be a sign of a clogged cooling system.
First of all, be aware that not all furnaces have a reset button; however, most do. If your electric furnace has one, it’s most likely located within the blower housing, next to the motor. If you own a gas furnace, it’s probably located within the control panel.
Where is the blower motor located on a Dodge Dakota?
And then pull this down and off of the blower motor. Once you have it released go ahead and check it for corrosion. And set it aside.
What happens when the blower motor resistor goes out?
No air coming to the vents at all. And should this happen you’re going to be very hot or cold in extreme weather conditions. Yes you can roll the windows down but that’s not always convenient.
Does the blower motor control the fan?
Anytime your thermostat communicates to your heating or cooling system that the temperature settings are not being met, your system will kick on. It’s the job of your blower motor to then operate the fan to circulate that produced air.
How do you remove a resistor from a blower motor?
And put them someplace. Safe. At this point you can remove the resistor from the housing disengage. The wire harness locking tab and disconnect the wire harness from the blower motor. Resistor.
How do I know if my blower motor resistor is bad?
The first symptom is the blower motor only works in the highest. Setting i would say this is the most common symptom related to a bad resistor. The second symptom is no air coming from the vents.
Why is my Dodge Dakota AC not blowing?
The most common reasons a Dodge Dakota ac isn’t working are a refrigerant leak, an electrical climate control issue, or a problem with the air conditioning compressor.
