Location of the Blend Door Actuator on a 2014 Chevy Captiva
The blend door actuator on a 2014 Chevy Captiva is located behind the glove box, mounted in view. It is a small electronic module that controls the blender door, which is responsible for mixing warm and cool air to be sent to the vents.
Please note that there may be multiple blend door actuators in vehicles with separate front and back climate control systems. However, for the 2014 Chevy Captiva, the blend door actuator is located behind the glove box.
I hope this helps! Let me know if you have any other questions.
Contents
- Why is my car blowing but no heat?
- What does it cost to replace a blend door actuator?
- Why is the heat not working on my Chevy Captiva?
- How much does it cost to fix a bad blend door actuator?
- How do I reset a blend door actuator?
- How do I know if my blend door actuator is bad?
- What happens when a blend door actuator goes out?
- Where is my blend door actuator located?
- Can I drive with a bad blend door actuator?
- Where is the temperature sensor on a Chevrolet Captiva?
Why is my car blowing but no heat?
If one or more of these issues is present, your vehicle may blow out cool air rather than heat: Not enough coolant in the engine. Problems with the heater core. Clogged or broken heating controls.
What does it cost to replace a blend door actuator?
between $342 and $396
The average cost for a HVAC Blend Door Actuator Replacement is between $342 and $396. Labor costs are estimated between $209 and $263 while parts are typically priced around $133. This range does not include taxes and fees, and does not factor in your unique location. Related repairs may also be needed.
Why is the heat not working on my Chevy Captiva?
The most common reasons a Chevrolet Captiva Sport heater isn’t working are a broken heater blower motor, a problem with the thermostat, or a failed heater blower motor resistor.
How much does it cost to fix a bad blend door actuator?
between $200 and $500
If you choose to have a professional replace your car’s blend door actuator, you can usually expect to pay somewhere between $200 and $500 to get the job done. Of course, the exact blend door acturator repair cost will depend on various factors, such as the year, make, and model of your vehicle.
How do I reset a blend door actuator?
Reading about 38 degrees Celsius. Step 4. Shut down the car. After. The three minutes have elapsed go ahead and turn off your car step 5. Reinstall the fuses.
How do I know if my blend door actuator is bad?
On hot on. The flip side the third symptom could be the temperature stuck on cold similarly. To the previous.
What happens when a blend door actuator goes out?
The most common symptom of the A/C Actuator going bad or when the Blend Door is stuck is when you feel inconsistent air flow coming in. The desired air you want whether it be hot or cold, is being diverted incorrectly, so you are not getting a consistent temperature out of the A/C system.
Where is my blend door actuator located?
And a connector. And you can pop those right out in most cases if you have a clicking noise or there’s a problem with the actuator.
Can I drive with a bad blend door actuator?
The blend door actuator doesn’t affect how your car drives as it is purely a feature of comfort inside the main cabin. When it breaks, you might notice some strange noises or you might have difficulty adjusting the temperature in your car which can be very inconvenient.
Where is the temperature sensor on a Chevrolet Captiva?
The ambient temperature sensor (switch) is located either behind the front grille or in the front bumper. Its only job is to monitor air temperature (which it does through increasing/decreasing resistance in response to temperature fluctuations).
