Location of BCM Fuse on a 2017 Ford Explorer
The Body Control Module (BCM) fuse on a 2017 Ford Explorer is located in the engine compartment fuse box. The specific fuses for the BCM are numbered 48 and 50 in the underhood fuse box.
To access the engine compartment fuse box, you can follow these steps:
1. Release the two latches located on both sides of the fuse box.
2. Raise the inboard side of the fuse box from the cradle.
If you need to replace the BCM fuse, it’s important to ensure that the replacement fuse has the same firmware as the original and is programmed (as built) to your vehicle. Always disconnect the battery before servicing high current fuses.
I hope this helps you locate the BCM fuse on your 2017 Ford Explorer!
Contents
- Where are BCM fuses?
- Where is the main fuse located?
- What is BCM on fuse panel?
- Where is the secondary fuse box?
- Where is the body control module fuse located?
- Where is the BCM on a 2017 Ford Explorer?
- Where is the internal fuse box?
- What is secondary fuse?
- What is a BCM on a Ford Explorer?
- How do I reset my BCM?
Where are BCM fuses?
Side. Two. Here okay and one. Here. Comes out now the third fuse from left to right this fuse right here is for the bcm. Also fuse number four is for bcm. This one here these two fuses.
Where is the main fuse located?
It says 10 it’s a 10 amp fuse. So any electrical current draw over 10 amps will blow the fuse. So as not to cause a wire to melt somewhere deeper in the wiring harness fuses are easy to replace.
What is BCM on fuse panel?
The Body Control Module is a generic term for an electronic control unit, responsible for monitoring and controlling various electronic accessories in a vehicle’s body. Typically, in a car, the BCM controls the power windows, power mirrors, air conditioning, immobilizer system, central locking, etc.
Where is the secondary fuse box?
The secondary under-hood fuse box is next to the battery. To open it, push the tabs as shown. If something electrical in your vehicle stops working, check for a blown fuse first. Determine from the chart on pages and , or the diagram on the fuse box lid, which fuse or fuses control that device.
Where is the body control module fuse located?
And realize. It is guys very important to test fuses. And relays on those fuses. You cannot clearly receive their burnt or not especially. You can see in the jks fuses as well.
Where is the BCM on a 2017 Ford Explorer?
2017 Ford Explorer, in wreckHand running out of my new key fob has been programmedThe BCM is under the instrument panel on the driver side.
Where is the internal fuse box?
Show you what every fuse is and what it does what the amperage is and what it controls. Now remember I said the cigarette mirror. Right there is that fuse it’s a 20 amp cigarette mirror fuse.
What is secondary fuse?
The secondary fuse is placed after the transformer’s out- put points of connection on the secondary side. It acts as overload protection for the transformer, and the total value of the fuses per phase must not exceed the secon- dary current specified on the rating plate.
What is a BCM on a Ford Explorer?
An electronic control unit that monitors and controls various electronic systems in a vehicle’s body, and communicates with other on-board computers via the car’s vehicle bus.
How do I reset my BCM?
Just remove both cables from the battery and touch the ends of the cables together to bleed off the voltage stored in the BCM capacitors, which resets the BCM’s memory and erases trash data. The original programming is non-volatile and will always remain.
