Where does the coolant go in Dodge Ram 1500?

Where does the coolant go in a Dodge Ram 1500?
To add coolant to a Dodge Ram 1500, you will need to locate the coolant reservoir. The coolant reservoir is typically a translucent plastic tank located near the radiator. It is important to note that the exact location of the coolant reservoir may vary depending on the specific model and year of the Dodge Ram 1500.
To add coolant, follow these steps:
1. Make sure the engine is cool before opening the coolant reservoir to avoid the risk of burns.
2. Locate the coolant reservoir and remove the cap.
3. Slowly pour the coolant into the reservoir until it reaches the “Full” or “Max” line. Be careful not to overfill.
4. Replace the cap securely.
It is recommended to use the coolant specified in the owner’s manual. For example, the owner’s manual for a 2007 Dodge Ram 1500 specifies HOAT coolant, which is a light red or orangeish color.
Always refer to the owner’s manual for the specific coolant type and any additional instructions or recommendations for your Dodge Ram 1500.
Please note that if you are unsure or uncomfortable performing this task yourself, it is recommended to consult a professional mechanic or refer to the Dodge Ram 1500’s official documentation for guidance.
I hope this helps! Let me know if you have any other questions.

What kind of coolant does a Ram 1500 take?

90032 OAT coolant type is the preferred premixed formula specification.

Do you add coolant to radiator or reservoir?

Remove the cap completely. If the coolant level is low, add the correct coolant to the reservoir (not the radiator itself). You can use diluted coolant by itself, or a 50/50 mixture of concentrated coolant and distilled water. When coolant rises to the cold fill line, replace cap and tighten it until you feel it click.

Is coolant and antifreeze the same thing?

Key Takeaways:
Coolant is a fluid used in the radiator to remove the engine’s heat. Antifreeze is an additive mixed with water or coolant to prevent your car engine from freezing in cold weather. The ratio of water or coolant to antifreeze should be 50:50.

Where do you put coolant in a Ram 1500?

If you need it. So as we showed you the engine coolant compartment is over here. And we can basically just open up this little plug here. And it’s going to give us a look inside of the reservoir.

Where do I find coolant to use?

You should check your owner’s manual, to check on what type or color of antifreeze your car takes. One of the most common, and longstanding coolants of this type is DEX COOL®, which was developed by GM in the late 1980’s and has been used ever since.

Can I just add coolant to my truck?

Simply adding the same type of coolant when your car is running a little low is completely fine. You do need to have the system flushed from time to time, but adding in between is fine.

How do I know if my truck needs coolant?

How to Know if Your Car Needs Coolant

1. Warning light on the dash.
2. A sweet smell coming from the engine.
3. Reduced gas mileage.
4. Puddle under your car with orange, green, or pink fluid.
5. The heater isn’t working properly.
6. The temperature gauge needle is inaccurate.

Where is the coolant tank located?

Most of these coolant reservoirs are made from durable plastic and are installed on the upper right hand side of your car’s engine compartment. These are an integral part of a car’s system because they help its entire cooling system.

Where do I put coolant in my truck?

Once the cap is out of the way we can add coolant until it’s up to the cold fill line. Next. We’re going to start the engine.

Will radiator pull coolant from reservoir?

As the warmth rises, coolant expands and overflows into the coolant reservoir and is then sucked back into the radiator as your car cools down after shut-off.