Where do you put the jack stands on a Ford Focus?

To properly place jack stands on a Ford Focus, you should follow the indicated jack points on the car. These jack points are clearly marked by arrows on the plastic trim of the vehicle. Here are the recommended locations for placing jack stands on a Ford Focus:
– Front: Place the front jack stands on either side directly under the lower control arms of the pivot bracket.
– Rear: Place two rear jack stands directly beside each other in the middle of the rear, right under the subassembly cross-member.
It’s important to note that the front subframe lifting point is not suitable for supporting the vehicle with a jack stand due to being off-center. Always ensure that the jack stands are securely positioned and that the vehicle is stable before working underneath it.

Where should jack stands be placed?

If you’re lifting the car to get under it, to do some work, or to change the oil, you must place a jack stand under the rocker panel near the jack and snug it up to the car’s body. This will ensure that the car cannot fall on you, should the jack slip or fail entirely.

Where do you put the jack on a Ford?

Stand. You can now remove the wheel if needed for safety slip it under the vehicle as additional protection.

Can you put jack stands under the axle?

It depends what you are working on! If I were working on the axle, I’d put them under the chassis frame (or jacking points on a monocoque vehicle), but if I was working on the shell, brakes, diff etc I usually put them under the axle tube.

Can you put jack stands on pinch welds?

Yeah, the pinch weld can be jacked anywhere. I’ve done it before where I jacked on the front edge and put the stand on the actual lift point behind it.

Where do you put the jack stands under a Ford Focus?

Both sides should be supported in most situations. The acceptable jack stand locations are the reinforced areas of the rocker panels (the same locations for jacking), the rear subframe, and the rear-most mounts of the front control arms.

How do you jack up a 2013 Ford Fusion?

Now slowly lower the car to rest on the jack. Stands. Once all stands are in place give the car a slight push to ensure the vehicle is secure before moving underneath it to work.

Where do jack stands go in the rear?

Locate the jack point on the vehicle
Your owner’s manual should give you the location of jack points. Usually there’s one on each side behind the front wheels and in front of the back wheels, close to the rocker panels. There may be central jack points located behind the bumpers (front and rear).

Where is the jack on a 2014 Ford Fusion?

But it’s a bit too medial to the vehicle. And the trolley Jack I’m using is on the smaller side like I mentioned before you can use the side metal piece here as the jack point as. Well.

How do you jack up a 2013 Ford Focus?

Strong good solid place right here to put your jack. Stand or you can also use it to jack up here. And put the stand there if you’d. Like.

How do you jack up a 2004 Ford Focus?

Okay if you want to lift up your for focus you can see right under this pinch weld on the body that’s where you want to place your jack. You could also if you want our jack up each wheel.