Where do you put the jack stands on a Chevy Cobalt?

To properly place jack stands on a Chevy Cobalt, you should use the designated jacking points. Here are the recommended locations:
1. Front Jacking Points: The front jacking points are located under the control arms or frame welding furthest back. You can use a floor jack to lift the front of the car at these points and then place the jack stands further forward for support.
2. Rear Jacking Points: The rear jacking points are located under the spring carriages, right under the control arm on either side. Use a floor jack to lift the rear of the car at these points and then place the jack stands underneath for support.
It’s important to ensure that the jack stands are securely positioned and that the car is stable before working underneath it. Always follow the manufacturer’s instructions and exercise caution when working with a vehicle.
Please note that the information provided is based on search results and may vary depending on the specific model and year of the Chevy Cobalt. It’s always a good idea to consult the owner’s manual for the exact jacking points for your vehicle.

How do I raise my car to work underneath?

How to Safely Work Under a Car Without a Lift

1. Jack Stands. Jack stands are a low cost and safe way to easily perform maintenance on the underside of your car.
2. Creepers. A mechanic’s creeper is one of those devices that you’ve likely seen on television or at auto shops.
3. Air Lifting Bag, or Air Jack.
4. Wheel Cribs.

Where do you put axle stands under a car?

Here. Put your axle stand in position raise. It up and make sure you use the locking. Pin. Though the jacks slowly onto the stand and repeat on the other side if needs. Be.

Where not to put jack stands?

Find a flat, level surface to park your vehicle.
Avoid jacking your vehicle in a place that’s bumpy, near heavy traffic, or covered in gravel. Make sure each side of your vehicle is level so the jack or jack stands can’t slip out from underneath it.

Can you put jack stands on pinch welds?

Yeah, the pinch weld can be jacked anywhere. I’ve done it before where I jacked on the front edge and put the stand on the actual lift point behind it.

Can you put jack stands on the axle?

As a backup. And then just check that the car is nice and stable and secure on the axle. Stand. Okay so you can go ahead and remove the wheel.

How many jack stands do I need?

If it’s just one end, use two jack stands. If it’s the entire vehicle you’re lifting, be sure to use four. In case you’re working on soft earth, like grass or asphalt, you can place thick plywood to prevent the jack stands from sinking.

Where do you put the jack stands on a Cobalt?

Just jack the car up via the jack pads on the side and put jack stands under the fore-aft sections of the subframe and you should have more than enough clearance for a drain pan, as well as a considerably safer working situation.

How do you know where to put the jack?

Locate the jack point on the vehicle
Your owner’s manual should give you the location of jack points. Usually there’s one on each side behind the front wheels and in front of the back wheels, close to the rocker panels. There may be central jack points located behind the bumpers (front and rear).

Where should jack stands be placed?

If you’re lifting the car to get under it, to do some work, or to change the oil, you must place a jack stand under the rocker panel near the jack and snug it up to the car’s body. This will ensure that the car cannot fall on you, should the jack slip or fail entirely.

How do you jack up a Chevy Cobalt?

Again you’re going to go jack right under the weld. You can also if you’re looking to just lift up a tire you can Jack right under the subframe. Here. Probably want a jacket.