When to Replace a Subaru Timing Belt
The recommended timing belt replacement interval for Subaru vehicles can vary depending on the model and year. However, the general guideline is to replace the timing belt between 60,000 and 105,000 miles, with some models recommending replacement at 105,000 miles.
It is important to note that the timing belt should also be replaced after seven years, regardless of mileage, to prevent potential failure. This is because the timing belt is made partially of rubber, which can degrade over time.
To determine the specific timing belt replacement interval for your Subaru, it is best to consult your owner’s manual or contact a Subaru dealership for the most accurate information.
Importance of Timing Belt Replacement
Replacing the timing belt is a crucial maintenance procedure for your vehicle. If the timing belt breaks, it can cause serious engine damage, especially in Subaru engines, which are interference engines. In an interference engine, if the timing belt breaks, the valves and pistons may collide, leading to costly repairs or even the need for a new engine .
Therefore, replacing the timing belt at the recommended service interval is essential to prevent engine damage and ensure the longevity and proper functioning of your vehicle.
Additional Considerations
When replacing the timing belt, it is common for technicians to also replace the water pump. This is because the water pump is located in the same area as the timing belt, and since both components are difficult to access, it is more cost-effective to replace them together. Additionally, the water pump has a similar lifespan to the timing belt .
It is worth noting that some Subaru models may have specific recommendations for tensioner bearing replacement. While the Subaru logbook may not mention service intervals for tensioner bearings, it is recommended to inspect and replace them at the same time as the timing belt to ensure optimal performance and prevent potential failures.
In conclusion, it is important to replace the timing belt in your Subaru according to the recommended mileage or time intervals to avoid engine damage and ensure the longevity of your vehicle. Consult your owner’s manual or contact a Subaru dealership for specific recommendations based on your model and year.
Contents
- How long do Subaru timing belts last?
- Will a timing belt last 200000 miles?
- When should I replace my Subaru belt?
- What are symptoms of a timing chain going bad on a Subaru?
- How much does it cost to replace a timing belt in a Subaru?
- When did Subaru switch from timing belt to chain?
- Do Subaru timing chains need to be replaced?
- Do Subarus have timing belt issues?
- How long does a Subaru timing chain last?
- How often do Subaru timing belts break?
How long do Subaru timing belts last?
We at Subaru Clinic recommend you replace your timing belt at 105,000 miles. That said, check your owner’s manual for recommendations.
Will a timing belt last 200000 miles?
The best guide would be the car handbook to see what the manufacturer mileage recommendations are. It is safer to replace the timing belt even earlier than the manufacturer recommends. In general, however, timing belts needs to be replaced from 60,000 miles up to 150,000 miles.
When should I replace my Subaru belt?
Generally, this replacement interval is between 50,000 and 100,000 miles. Consult your owner’s manual or contact our service department for information regarding your specific vehicle’s service recommendations.
What are symptoms of a timing chain going bad on a Subaru?
Signs of a Faulty or Failing Timing Chain
One of the most common signs of a faulty timing chain is a rattling sound when you start the engine, let it idle, or brake. That rattle is a loose chain banging against the housing it’s in, indicating the chain is stretched beyond what it should be.
How much does it cost to replace a timing belt in a Subaru?
Shopping around to get a few quotes is your best bet to get the best deal, but you can expect to pay anywhere from $409 to $919 (including parts and labor). Have a timing chain instead of a timing belt? Lucky you, because they can actually last the lifetime of your car.
When did Subaru switch from timing belt to chain?
2011
Subaru engines used belts , except for the boxer ez. 3.6 and diesel engines until about 2011. 2012-up 4th generation Subaru used chains and on newer engines.
Do Subaru timing chains need to be replaced?
A timing chain is bulkier and louder; however, it does not require replacement. Though a repair might be necessary in some rare occasions, most timing chains last for the entire life of the engine.
Do Subarus have timing belt issues?
Subaru has a recommended timing belt service interval of 105,000 miles, however there have been cases where timing belt failure has happened at just 25,000 miles. Inspection of the timing belt is recommended every oil service to aid with early detection.
How long does a Subaru timing chain last?
Timing BELTS are required to be replaced every 100k. Timing CHAINS, which you have, are generally good for the life of the engine. Just change your oil and you’re good. Timing belts (not chains) should be replaced approximately every 100k miles.
How often do Subaru timing belts break?
every 105,000 miles
The timing belt should be replaced as per manufactures recommendation. For Subaru vehicles it is every 105,000 miles or 10 years. If the timing belt service is neglected, major engine damage can result from the belt snapping.
