What size tool is a Ford fuel line disconnect?

The Size of a Ford Fuel Line Disconnect Tool
The size of a Ford fuel line disconnect tool can vary depending on the specific model and year of the vehicle. However, based on the search results, it seems that the most commonly used sizes for Ford fuel line disconnect tools are 5/16 inch and 3/8 inch.
These sizes are compatible with a wide range of Ford vehicles, including those from 1990 to the present. It is important to note that some Ford models may have different fuel line sizes, so it is always recommended to consult the vehicle’s manual or a trusted mechanic for the exact size needed.
Using a fuel line disconnect tool of the appropriate size is crucial for safely and efficiently disconnecting the fuel line from the connector without causing damage. These tools are designed to apply the right amount of pressure on the connection, making the disconnection process easier and minimizing the risk of accidents or injuries.
If you are planning to work on your Ford vehicle’s fuel line, it is advisable to use a fuel line disconnect tool of the correct size to ensure a proper fit and avoid any potential issues.
I hope this information helps! Let me know if you have any other questions.

How do you use a metal fuel line disconnect tool?

And then press inward on it forcing the clips. Open. And then the fuel line should pop off to a place to feel wine just push it back on till you hear it snap. And then replace the safety clip.

Is 3 8 the same as 6AN?

Hose diameters are assigned AN numbers. Using your automotive hose size, choose from the chart below to find the AN equivalent for hose, hose ends and adapter fittings. For example: a 3/8″ standard hose equals -6 AN.

What size are fuel line fittings?

The sizes typically used in fuel systems are AN6 / Dash 6 / -6, which equates to a thread measuring 9/16” x 18 (threads per inch) with a hose bore around 3/8”, and AN8 / Dash 8 / -8 which has a thread measuring 3/4” x 16 (threads per inch) with a hose bore of around 1/2”.

How to make a fuel line removal tool?

Well is to take bicycle handlebar and cap. And all you do is cut a notch out of it using a dremel and then obviously cut the tabs there cut the tab. As well. And kind of shave down each of the tabs.

What tool is used to loosen and tighten fuel line fittings?

Diesel Injector Fuel Line Sockets are used to loosen and tighten nuts and bolts in confined spaces such as fuel injector connections.

What size is the fuel line disconnect on a Ford?

5/16 x 3/8
CTA Tools 1810 Ford Fuel Line Disconnect Tool – 5/16 x 3/8.

How do I disconnect my Ford fuel lines?

Difficult. It’s going to take quite a bit of wiggling. Quite a bit of finagling. But eventually. Once you push down in the correct way the line will come apart.

What is a fuel line disconnect tool?

The fuel line disconnect tool is a specialty device used to release fuel line connectors. The tool is normally designed to fit into tight places and disengage fuel line fittings near fuel filters, fuel sending units, and on the fuel rail.

How do you remove a fuel line connector from a fuel line?

And just basically pull the horseshoe up and out. Now you can slide the fitting. Off to install this fitting you’ll have to install a new horse chute clip into the fitting.

How do you use a quick disconnect tool?

And then press inward on it forcing the clips. Open. And then the fuel line should pop off to a place to feel wine just push it back on till you hear it snap. And then replace the safety clip.