What size socket is the oil pressure sensor on a 2013 Chevy Silverado?

Oil Pressure Sensor Socket Size for 2013 Chevy Silverado
The oil pressure sensor socket size for a 2013 Chevy Silverado is 1 1/16″. This size is commonly used for the oil pressure sending unit (gauge type) found on most ’91 and newer GM vehicles, including the 2013 Chevy Silverado.
The specific socket required is the Lisle 13250 Oil Pressure Switch Socket, which fits 1 1/16″ switches up to 2 5/8″ long and is designed for newer GM vehicles, including the Chevy Silverado.
So, if you need to replace the oil pressure sensor on your 2013 Chevy Silverado, you would need a 1 1/16″ oil pressure sensor socket, such as the Lisle 13250, to effectively perform the replacement.
I hope this helps with your maintenance needs! If you have any more questions or need further assistance, feel free to ask.

What is the code for the oil pressure sensor on a 2013 Chevy Silverado?

P0521
The two most common error codes for the Chevrolet Silverado oil pressure sensor issue are P0521 and P0523.

What tool do you need to change oil pressure sensor?

This will give us access easier to the back side of the intake. Manifold. I like to tackle this from the driver’s side of the vehicle. It’s down against the firewall.

What is the oil pressure for a 2013 Chevy Silverado 1500?

GMs factory oil pressure specs on your 2013 Silverado with the 5.3 engine call for 22 PSI at 1,000 engine RPM, 30 PSI at 2,000 engine RPM and 33 PSI at 3,000 engine RPM with the engine warmed up.

Do I need a special socket for oil pressure sensor?

That means if you have the original unit in your car you will either need both special removal tools or just the 1&1/16 removal tool and a regular 1&3/16 socket that you can use if you remove the metal cylinder from the old unit while it’s in the block, but I wouldn’t recommend that unless you happen to actually have a …

Do I need to drain oil to replace oil pressure sensor?

NO, you do not, you just have to find the sensor, I would suggest you” wire brush it” then start the engine, warm it up to make it easier to remove.

Is oil pressure sensor and oil level sensor the same?

An oil level measures the amount of oil that is in your car by quarts and an oil pressure sensor tells you how many pounds ,per square inch, that your oil pump is pumping through out your engine.

Can I drive with a bad oil pressure sensor?

The issue could be an actual loss of oil pressure inside the engine. So, to minimize the chance of costly internal engine damage, you should shut the car off immediately whenever there’s a low oil pressure warning displayed on the dash. Then have the vehicle towed to your destination of choice for diagnosis.

Is oil pressure switch and oil pressure sensor the same?

An oil pressure sending unit is also known as an oil pressure switch or even an oil pressure sensor. Oil pressure sending unit is a less common name for the component these days. No matter what the part is referred to, all three serve the safety purpose of monitoring your oil pressure.

What is the code for low oil pressure on a Silverado?

P0521
The P0521 code is one of the trouble codes that denotes a potential problem with the engine oil pressure switch or engine oil pressure. If your code reader or scanner registers it, read this comprehensive guide to learn about its meaning, probable causes, common symptoms, and more.

What size is the oil pressure sensor socket?

1-1/16 Inch 27mm
Oil Pressure Sensor Switch Socket for Special Size 1-1/16 Inch 27mm (Min) X 28.3mm(Max) Socket Switch 2-1/4 Inch Deep for Chrys ; Check OEM NO. Compatible with Vehicle in Details.