The strut nut size on a Toyota varies depending on the specific model and year. However, based on the search results, it seems that the most common size for the strut nut on Toyota vehicles is 14mm. It’s important to note that this information may not apply to all Toyota models, so it’s always best to consult the vehicle’s manual or contact a Toyota dealership for the most accurate information.
Contents
- How do you remove a strut top nut?
- How do you remove lower strut bolts?
- What is bolt on top of strut?
- How tight should I tighten my shocks?
- How do you tighten a strut mount nut?
- What tool is used to tighten strut bolts?
- How do I keep my strut from spinning when I tighten it?
- What is the nut on top of a strut for?
- What size nut for shock absorber top?
- What happens if you over tighten a strut?
How do you remove a strut top nut?
And. So as you can see I put the end of the end of the piston in there and just cranked a crap on them you really gotta crank it tight. I’ve tried using vise grips on it.
How do you remove lower strut bolts?
For our lower strut mounting bolts all right should be about finger. Tight all right there we go flip this guy out of the way there these are the bolts we’re aiming.
What is bolt on top of strut?
That top-middle nut connects to the strut rod, and keeps the assembly together. It can be removed by using an Allen to hold the strut while turning the nut by using a pass-through ratchet, BUT it should only really be removed after using spring compressors to compress the spring on the assembly.
How tight should I tighten my shocks?
The fasteners should be tightened until the bushing expands (bulges) to the same outside diameter of the metal washer. (see below] This allows for the proper amount of bushing squeeze so that the shock absorber can move properly in any direction.
How do you tighten a strut mount nut?
There we’re going to pulse. This so that it goes. On you see my hand. I can’t hold. That because it’s an impact gun it’ll turn the nut faster than the shaft. It’s still not tight.
What tool is used to tighten strut bolts?
Strut Nut Socket | 19mm
12 point socket with cut away profile for servicing strut nuts. The cut away design allows access for a hex key to hold the strut while tightening the nut to the specified torque with a torque wrench (hex key is not supplied).
How do I keep my strut from spinning when I tighten it?
Use an allen wrench to hold the rod end and prevent spinning. To keep the piston shaft from spinning while tightening up the top nut on your shocks, we recommend using a 5mm or 6mm allen wrench (it could be either so confirm) on the top of the rod end to hold the rod from spinning while you tighten the nut down.
What is the nut on top of a strut for?
The top nut, which holds the shock absorber’s piston rod and upper mount in place (Photo 1), must be tightened at the prescribed torque with a torque wrench. A loose top nut will cause noise while driving, in the worst case damaging the shock absorber and/or the vehicle.
What size nut for shock absorber top?
Standard top nut is M14x1. 5. Hex size on the nut is 21mm.
What happens if you over tighten a strut?
Do not use an air or electric impact wrench to tighten the upper mounting nut on the piston rod. This can make the torque higher than recommended and cause damage.
