Crankshaft Bolt Size for a 2009 Honda Accord
The crankshaft bolt size for a 2009 Honda Accord is 19mm.
Contents
- What size is the crankshaft sensor bolt?
- What size is the thread on a crankshaft?
- What bolt holds the crankshaft in place?
- What is the standard size of a crankshaft?
- What size are crank bolts?
- How do you remove a crankshaft pulley bolt?
- What size socket do I need to turn my crankshaft?
- What size is the crankshaft pulley nut?
- What tool removes crankshaft pulley?
- Is a Honda crank pulley bolt reverse thread?
What size is the crankshaft sensor bolt?
M6 x 1 x 20mm bolt for use with all LS crankshaft position sensors.
What size is the thread on a crankshaft?
RE: Thread size on crankshaft
The metric shaft has a 1mm pitch or 25.4 threads per inch. 5/16″ – 24 has 24 threads in one inch.
What bolt holds the crankshaft in place?
What holds your crankshaft in place are the main caps. These are what the crank bearings sit in. Most engines have 5 caps. A 2 bolt cap is fastened to the block with 2 bolts, and a 4 bolt cap has 4 bolts (2 on each side).
What is the standard size of a crankshaft?
Crankshaft Standard Shaft Diameter: 36mm; (1)The size is Shaft Diameter, Not Connecting rod and crankshaft inner Diameter. (2)Increase the size, the shaft diameter is reduced, the connecting rod and crankshaft bearing thickness increase.
What size are crank bolts?
The bolt diameter is 8mm and there is 1mm betwween thread peaks. This size is by far the most common. However there are other standards. Truvativ seems to have the most variations using M8, M12, M15 plus some self extracting bolts.
How do you remove a crankshaft pulley bolt?
And we’re going to loosen it up. And it’s that easy that belt will pinch upon itself. And that provides the grip. So that you can put any amount of torque on the fastener.
What size socket do I need to turn my crankshaft?
You can use a 38mm or 1.5 inch socket on the crankshaft nut.
What size is the crankshaft pulley nut?
Mine is 38mm, but 1 1/2 socket fits too. I just bought a 1/2 drive 1 1/2 socket because it takes up less room than my 3/4 drive 38mm when I’m tight for space and they both work fine. Eliseo, I’m pretty sure both of the prior posts are correct. It depends on which pulley your engine is using.
What tool removes crankshaft pulley?
But in general you need a ‘harmonic balancer removal/install tool‘. Also commonly referred to as a ‘crank pulley tool’.
Is a Honda crank pulley bolt reverse thread?
This is a regulat thread bolt, righty tighty lefty loosey. However, there is a special tool to hold the pulley in place while using a LOOONG breaker bar to break the bolt free. Using an impact gun on this bolt can damage the beaings on the crank.
