What size bolt is a Honda crank pulley?

Honda Crank Pulley Bolt Size
The size of the bolt that holds the crankshaft pulley on a Honda varies depending on the specific model and year. Here are the sizes mentioned in the search results:
– Honda Civic / Del Sol (1992 – 2000): The bolt size for the crankshaft pulley on a ’99 LS B18B motor is not explicitly mentioned in the search results.
– ’96 Civic EX: The size of the socket needed to get the crankshaft pulley off a ’96 Civic EX is mentioned as 17mm in one of the search results.
– Honda Accord: The crank pulley bolt size for the Honda Accord is mentioned as 19mm in the search results.
– S2KI Honda S2000 Forums: The crank pulley bolt size is mentioned as 16mm with a 1.5 pitch on the threads in this source.
Given the varying information, it’s important to consult the specific vehicle’s manual or a reliable mechanic to confirm the correct size for the crank pulley bolt.
If you need further assistance or have any other questions, feel free to ask!

Are all crank bolts the same size?

Most are the same size, use a 5 mm Allen bolt and a nut on the back side that takes a pin spanner. They fit a 10 mm hole. Some older cranks, mid-80s and earlier lower end models used oddball, un-obtainable bolts, usually with a smaller diameter hole.

How to remove a crankshaft pulley bolt?

And we’re going to loosen it up. And it’s that easy that belt will pinch upon itself. And that provides the grip. So that you can put any amount of torque on the fastener.

What size is the crank bolt on a Honda Prelude?

Crankshaft Pulley Bolt (16x49mm) – Compatible with 1993-2001 Honda Prelude.

What size are 351 Windsor head bolts?

The 351W motors featured 1/2″ head bolts, unlike the smaller 7/16″ bolts found on factory 79-95 302 5.0L motors.

What size is the crankshaft pulley nut?

Yes, the crank nut is 38mm or 1.5″ hex. Typically torqued to just a pinch over 100 ft/lb. That size socket should not be difficult to obtain at very modest cost.

What tool removes crankshaft pulley?

But in general you need a ‘harmonic balancer removal/install tool‘. Also commonly referred to as a ‘crank pulley tool’.

Is the harmonic balancer bolt same as crankshaft bolt?

No! They are two different things. The harmonic balancer slides onto the front of the crankshaft which has a keyway on it to keep it from slipping and a bolt and wide washer holds it in place.

What size bolt is a 351w harmonic balancer?

It’s a 15/16, and get an impact socket because that’s the only way you can loosen the bolt.

What is the common crank bolt size?

8mm
The bolt diameter is 8mm and there is 1mm betwween thread peaks. This size is by far the most common. However there are other standards.

Is a Honda crank pulley bolt reverse thread?

This is a regulat thread bolt, righty tighty lefty loosey. However, there is a special tool to hold the pulley in place while using a LOOONG breaker bar to break the bolt free. Using an impact gun on this bolt can damage the beaings on the crank.