What kind of transmission fluid does a Chevy Trax take?

Transmission Fluid for Chevy Trax
The type of transmission fluid required for a Chevy Trax depends on the transmission type. For the 2016 Chevy Trax, it uses Dexron VI fluid, with a capacity of 4.2 quarts or 4 liters for the initial fill. It’s important to note that for automatic transmission fluids (ATF), they are typically red or green to distinguish them from other types of oils.
The recommended standard for the Trax is GL-4 for manual transmission fluids. It’s important to use a GL-4 oil to prevent damage to the bronze synchronizers of the transmission caused by the sulfur found in GL-5 oils.
Conclusion
To summarize, for the 2016 Chevy Trax, the recommended transmission fluid is Dexron VI for automatic transmissions and GL-4 for manual transmissions. Always ensure to use the recommended fluid type and capacity for optimal performance and longevity of the vehicle’s transmission system.

Contents

Is it bad to use the wrong transmission fluid?
Does Chevy recommend transmission flush or change?
What’s the difference between ATF and Dexron transmission fluid?
Where is the transmission dipstick on a Chevy Trax?
What happens if you use the wrong transmission fluid?
How much transmission fluid does a Chevy Trax take?
Does it matter what transmission fluid I use?
What kind of transmission does a Chevy Trax have?
How often do you change the transmission fluid in a Chevy Trax?
What transmission fluid does Chevy recommend?

Is it bad to use the wrong transmission fluid?

Accidentally Use Wrong Transmission Fluid: Adding ATF to a CVT or vice versa is the most common situation of adding the wrong transmission fluid to your vehicle. This will eventually result in your transmission failing.

Does Chevy recommend transmission flush or change?

For a manual transmission, it’s generally recommended that you change the fluid every 30,000 to 60,000 miles. For an automatic it could be anywhere from 30,000 to 100,000 miles.

What’s the difference between ATF and Dexron transmission fluid?

Dextron is a General Motors approved trans fluid (there are a few versions), and ATF is a generic name for trans fluid. Dextron can and is used in many other makes of vehicles (not just GM), and you need to make certain you are putting the correct fluid in whatever car you own so research whatever applies.

Where is the transmission dipstick on a Chevy Trax?

Locate the transmission fluid dipstick. On front-wheel-drive vehicles, it’s likely located to the right of the oil dipstick.

What happens if you use the wrong transmission fluid?

Immediately after putting the wrong transmission fluid in your vehicle, you can start noticing issues while driving. In most cases, people notice strange noises, overheating, and slipping gears. Do not ignore these warning signs, because they will not go away on their own.

How much transmission fluid does a Chevy Trax take?

The Trax takes 3-qts to drain and fill. The Colorado requires 6-qts when the pan is dropped and filter replaced. Both vehicles perform at higher levels after an ATF service.

Does it matter what transmission fluid I use?

The type of transmission fluid you should use depends upon the make, model and year of your vehicle. For example, many General Motor cars will require a DEXRON fluid and Ford cars commonly specify a MERCON fluid. Always follow the vehicle manufacturer recommendation for proper fluid use and change interval.

What kind of transmission does a Chevy Trax have?

The 2024 Chevrolet Trax is available exclusively with a 1.2-liter turbocharged I3 that drives the front wheels, with a six-speed automatic transmission.