Transmission Fluid for 2006 Ford Five Hundred
The type of transmission fluid required for a 2006 Ford Five Hundred depends on the specific transmission model. There are two transmission models for this car: CFT30 and F21. It’s important to ensure the correct fluid type is used for each model. The fluid type is typically stamped on the dipstick and the dipstick handle. The amount of fluid needed can be found in the owner’s manual, under specifications and capacities.
For the CFT30 transmission model, the recommended transmission fluid is Automatic Continuously Variable Transmission (CVT) fluid, which is a full synthetic fluid. As for the F21 transmission model, the specific type of fluid is not explicitly mentioned in the provided search results.
It’s also worth noting that the transmission fluid should be changed periodically. For automatic transmissions, the transmission fluid is generally recommended to be changed every 25,000 to 30,000 miles. However, there is some confusion regarding the recommended interval for the CVT fluid replacement, with conflicting information between a Ford dealer and the maintenance schedule. The dealer suggests a 90,000-mile interval, while the maintenance schedule indicates a 60,000-mile interval for the CVT fluid replacement. It’s advisable to consult the owner’s manual or a certified mechanic for the most accurate information regarding the replacement interval for the CVT fluid.
It’s important to use the correct type of transmission fluid for the specific transmission model and to adhere to the recommended replacement intervals to ensure the smooth operation and longevity of the transmission system in the 2006 Ford Five Hundred.
Contents
- How much does it cost to replace a transmission in a 2006 Ford 500?
- How many quarts of transmission fluid does it take to fill?
- How much transmission fluid does a Ford 500 hold?
- What kind of transmission is in the Ford Five Hundred?
- Is Mercon the same as ATF?
- What transmission does the 2006 Ford Five Hundred have?
- What kind of oil does a 2006 Ford Five Hundred take?
- What transmission fluid does Ford 500 use?
- What type of ATF does Ford use?
- Does it matter what type of ATF you put in your transmission?
How much does it cost to replace a transmission in a 2006 Ford 500?
The average cost for Ford Five Hundred Transmission Rebuild is $3159.
How many quarts of transmission fluid does it take to fill?
In general, transmissions take about 9 to 13 quarts to fill completely. The amount of transmission you add will vary, depending on whether you are draining or replacing it all or you are just topping it up. Again, you should avoid adding too much. It is advisable to put in little amounts at a time.
How much transmission fluid does a Ford 500 hold?
Fill the transaxle with approximately 3.7L (4 qt) of clean transmission fluid.
What kind of transmission is in the Ford Five Hundred?
The Ford Five Hundred/Mercury Montego was powered by a single engine, shared with the Ford Taurus: a 203 hp 3.0L Duratec V6, paired with a 6-speed Aisin automatic transmission (for front-wheel drive versions) or a ZF CVT (for AWD).
Is Mercon the same as ATF?
Valvoline Mercon V ATF is the conventional automatic transmission fluid that has been uniquely engineered to extend the life of automatic transmissions in vehicles that specify all Mercon V and additional Mercon applications.
What transmission does the 2006 Ford Five Hundred have?
Six-speed automatic
Transmission: Six-speed automatic standard on most front-drive models; continuously variable automatic standard on all-wheel-drive versions and some front-drive models.
What kind of oil does a 2006 Ford Five Hundred take?
5W-20
Oil Grade: SEO15
| Viscosity: | All TEMPS….5W-20 |
|---|---|
| Capacity: | With filter 6 quarts. After refill check oil level. |
| Torque: | Oil Drain Plug…19 ft/lbs |
What transmission fluid does Ford 500 use?
FRAM – Full Synthetic Dexron VI Automatic Transmission Fluid: 1 Quart (Part No. F426)
What type of ATF does Ford use?
MERCON® transmission fluids undergo extensive testing, both in the lab and in real-world conditions, to ensure they provide optimum performance and durability. MERCON® fluids are the only fluids approved by Ford Motor Company for their recommended application.
Does it matter what type of ATF you put in your transmission?
The type of transmission fluid you should use depends upon the make, model and year of your vehicle. For example, many General Motor cars will require a DEXRON fluid and Ford cars commonly specify a MERCON fluid. Always follow the vehicle manufacturer recommendation for proper fluid use and change interval.
