Based on the search results, the 1957 Ford Thunderbird typically uses Dexron III transmission fluid. Dexron III is the recommended fluid for this model, according to the Vintage Thunderbird Club International and Ford Thunderbird forum sources. While some people may suggest using Type F fluid, Dexron III is considered the closest equivalent to the original Type A fluid.
It’s important to note that the transmission fluid requirements may vary depending on the specific Thunderbird model and any modifications that have been made. If you have any doubts or want to ensure the correct fluid for your particular vehicle, it’s always a good idea to consult the owner’s manual or reach out to a trusted mechanic.
Remember to check the fluid level regularly and follow the proper procedures for adding or changing the transmission fluid.
Contents
- Can you use Dexron 3 transmission fluid in a Ford?
- How much did a 1957 Thunderbird cost in 1957?
- What happens if you overfill transmission fluid?
- Is 4 quarts enough transmission fluid?
- What type of ATF does Ford use?
- How many quarts of transmission fluid does a Ford transmission hold?
- Does it matter what transmission fluid I use?
- Is Mercon the same as ATF?
- How many 1957 Thunderbirds exist today?
- What transmission is in 57 Thunderbird?
Can you use Dexron 3 transmission fluid in a Ford?
LUBRIPLATE Dexron III/Mercon is a premium fluid fully qualified to cover current requirements for both General Motors and Ford.
How much did a 1957 Thunderbird cost in 1957?
The 1957 T-Bird’s price had climbed to $3,408, but it remained an attractive buy. The 1957 Thunderbird was arguably the best 1950s T-Bird two-seater, although it lacked the clean lines of the first two models.
What happens if you overfill transmission fluid?
Excessive fluid prohibits proper lubrication and cooling and slows the rotating crankshaft, similar to the effect of running through water. When the air above mixes with the high levels of fluid, it creates a foamy substance that saturates the transmission. This can lead to: Part pitting.
Is 4 quarts enough transmission fluid?
Vehicles require an average of 4 to 17 US gallons (3.8 to 16 liters) of transmission fluid to fill; the majority of automobiles contain between 12 and 16 quarts (11.3 to 15.1 liters), depending on the car’s manufacture and other criteria.
What type of ATF does Ford use?
MERCON® transmission fluids undergo extensive testing, both in the lab and in real-world conditions, to ensure they provide optimum performance and durability. MERCON® fluids are the only fluids approved by Ford Motor Company for their recommended application.
How many quarts of transmission fluid does a Ford transmission hold?
| Transmission Fluid Capacity | |
|---|---|
| Transmission (w/ Stock Pan) | # of Quarts |
| Ford C4 | 5.5 |
| Ford C6 | 7 |
| Ford AOD/AODE | 6.5 |
Does it matter what transmission fluid I use?
The type of transmission fluid you should use depends upon the make, model and year of your vehicle. For example, many General Motor cars will require a DEXRON fluid and Ford cars commonly specify a MERCON fluid. Always follow the vehicle manufacturer recommendation for proper fluid use and change interval.
Is Mercon the same as ATF?
Valvoline Mercon V ATF is the conventional automatic transmission fluid that has been uniquely engineered to extend the life of automatic transmissions in vehicles that specify all Mercon V and additional Mercon applications.
How many 1957 Thunderbirds exist today?
In total, there were 21,380 Thunderbirds sold in 1957, each with one of three V8 engine options: D-, E- or F-Type. The vast majority were the D-Type V8, while 1,363 were E-Type, and just 197 were F-Type. There are only an estimated 40 F-Types left in existence today.
What transmission is in 57 Thunderbird?
Supplied on the base model T-Bird was a 290 cubic inch V8 mated to a 3-speed manual transmission, noted with a “D” designation on the car’s VIN. These made up the vast majority of the 21,380 cars sold in 1957.
