What kind of grease do you use on a Toyota drive shaft?

Type of Grease for Toyota Drive Shaft
When it comes to greasing the drive shaft of a Toyota, there are a few different recommendations from various sources. Here’s a summary of the information:
– Frequency of Greasing: It is recommended to grease the drive shaft every oil change, especially if the vehicle has been driven through a lot of dirt or water. This helps to flush out contaminants before they can cause harm.
– Recommended Grease Type: There are different opinions on the type of grease to use. Some sources recommend a good quality grease with calcium sulfonate as an additive, while others suggest using lithium-based NLGI No. 2 grease for the spider gear, and molybdenum disulphide lithium-based NLGI No. 2 grease for the slide yoke and double cardan joint .
– Other Opinions: Some individuals have mentioned using whatever grease is in the grease gun at the time, while others emphasize the importance of regular greasing over the specific type of grease used .
In conclusion, while there are different opinions on the type of grease to use for Toyota drive shafts, it is generally recommended to use a good quality grease with calcium sulfonate as an additive or lithium-based NLGI No. 2 grease for the spider gear, and molybdenum disulphide lithium-based NLGI No. 2 grease for the slide yoke and double cardan joint.
If you have further questions or need more specific guidance, it may be beneficial to consult with a Toyota dealership or a qualified mechanic for personalized advice.

What kind of grease to use on a 4runner drive shaft?

And clean those zerk fittings. And some gloves it’s a bit of a dirty.

What kind of grease do you use on Toyota u-joints?

Molybdenum disulphide lithium based ghassis grease NLGI No. 2 which you can buy at just about any auto store. I get mine at Autozone.

What kind of grease to use on a drive shaft?

Calcium sulfonate grease is, in our opinion, the best drive shaft grease. Any grease is better than no grease but if you want the best grease to ensure the longest life out of your drive shaft, this grease is what we recommend.

How do you lubricate a drive shaft?

Apply grease via the grease fitting until grease begins to come out of the welch plug vent hole. After grease appears in the vent hole, cover it and continue to grease until it begins to show grease in the seal. During re-lubrication it may not be possible to fully collapse the driveshaft.

How do you grease a driveshaft on a 3rd Gen 4runner?

And then screw it on that’ll lock on to that zerk. And then we can give this a few pumps. So you can kind of hear it I won’t be quiet here and you can hear.

What is the best grease for shaft bearings?

SKF LGWM 1 is a low consistency, mineral oil-based grease. The grease is highly suitable for lubricating bearings that operate under both radial and axial loads, such as on wind turbine main shafts. It is suitable for extreme pressure, low temperature applications.

Can you over grease a driveshaft?

If it is coming out around the slip yoke or at the end, it is likely that the slip yoke was overfilled with grease. Hopefully the excess will all get forced out, and it sounds like it is. The grease is coming out of the middle of the drive shaft (where it slides-extend or compress).

Can you lubricate a drive shaft?

Lubricants are essential for drive shafts.

How often should drive shaft be greased?

The recommended lubrication interval for Driveshaft’s used in Industrial plants in normal operating conditions is approximately every 500 hours. Unfavorable effects like temperature, dirt and water may necessitate shorter lubricating intervals.

What kind of grease to use on Tacoma drive shaft?

And find our connections on where we’re going to be inserting the grease. Okay we’re in an uncomfortable spot under the truck. This is the driver’s side Tire.