What kind of axle is on the Ford Excursion?

Ford Excursion Front Axle
The front axle on the Ford Excursion is a Dana 50. This axle consists of a Dana 44 differential in a Dana 60 housing with 30 spline axles. The Dana 50 axle is externally similar to a Dana 60 but has substantially smaller internal differential components, making it a bit on the weak side for these large trucks.
The rear axle for all Excursions is a Sterling 10.5 axle. The four-wheel-drive models are equipped with a NV273 transfer case and Dana 50 front axle. Rear axle ratios of 3.73:1 and 4.30:1 are offered.
If you need to find out the specific axle ratio for your Excursion, you can usually find a sticker on the inside of the driver’s side door jamb with a code that signifies which axle you have on your Excursion.

What vehicles came with a Dana 44 front axle?

Dana 44Identification:Roughly D-shaped cover with 10 bolts, 10 3/8 inches wide. Often (but not always), “44” is cast into a reinforcing rib of the differential housing. Found In:Front or rear of numerous Chevy, Dodge, Ford, Jeep, International, and Isuzu models.

What vehicles use Dana 44 axles?

The Dana 44 has been manufactured for nearly 70 years, and was original equipment under Jeep, Ford, GM, Dodge, International Harvester and Studebaker vehicles, and even the Isuzu Rodeo and Honda Passport. And almost every one of these had some unique, funky specification just for that model.

What Ford trucks have Dana axles?

Ford uses Dana Super 60 Front Driving Axles in 2005 and newer F250, F350, F450, and F550 Super Duty 4×4 trucks. Each axle is built with a Bill of Material (BOM) Tag affixed to the differential cover by two cover bolts. These axles will also…

Does Ford use Dana axles?

With a throwback to the past, the 2023+ Ford Super Duty F-250 and F-350 come equipped with the Dana Advantek M235 (Dana 50) front axle in high pinion configuration.

What axles are in a Ford Excursion?

2000-2005 Ford Excursion 4x4s use Dana 50 monobeam front axles.

What front axle is in a 2000 Ford Excursion?

The Excursion come from the factory with a Dana 50.

How do I know if I have Dana 44 axles?

Many Dana axles have the model ID cast into the fins or centersection. Look for a “44” or “60” cast into the reinforcement ribs. The number can usually be found on the lower right side rib below the differential cover, but it may also be found on other ribs or on top of the main cast structure.

How do I identify my Ford axle?

FORD AXLE IDENTIFICATION TAGS
The location of Ford identification tags will vary by model, but most are located on a carrier cover bolt. The Ring Gear Size (differential type) and the Gear Ratio will be printed on the tag (as well as whether or not the differential is limited slip).

What years did Ford use Dana 60?

2005-2016 Ford Dana Super 60 Front Axle Identification IDN-118. Ford uses Dana Super 60 Front Driving Axles in 2005 and newer F250, F350, F450, and F550 Super Duty 4×4 trucks.

Which Ford axle do I have?

1. View the Safety Compliance Certification Label on the driver’s side, front or rear door panel. 2. Find the word “AXLE” under the bar code.