AHG Auto Service » Make » Lexus » What is the TYRE pressure for Lexus NX300?

What is the TYRE pressure for Lexus NX300?

Recommended Tyre Pressure for Lexus NX300
The recommended tyre pressure for the Lexus NX300 is 32psi. This is equivalent to 220kPa and 2.2bar. It’s important to note that this advice is a general guide, and it’s recommended to consult the owner’s manual for specific tyre pressure figures for the Lexus NX300.
If you have further questions about the specific tyre pressure for your Lexus NX300, it’s best to consult your nearest Lexus Centre for personalized assistance.

Is 36 psi too high for tires?

Recommended tire pressures vary with the size of the car and its tires. Based on normal tire sizes for each segment, small-sized car are usually 30 psi, medium-sized cars are 36 psi, and large cars are 42 psi. Keep in mind that warm tires normally exceed recommended cold tire pressures by 4-6 psi.

How do you check tire pressure on a Lexus NX300?

Over on the left hand side. We have a couple different icons. Go ahead and click the second to last one that looks like a little card.

Does Lexus tell you which tire is low?

You can access the tire pressure levels in each of your tires through your driver display, and this system will alert you when it senses tire pressure is low in any of the tires, singling out the culprits for you.

What is a bad PSI for tires?

While you should always stay within this range, you should also never be below 20 PSI, or over 50 PSI, or you risk serious tire damage (more so than with standard overinflated or underinflated tires to a lesser degree). Your car may have different ideal tire pressures for the front and rear axles.

What should the tire pressure be on a Lexus 300?

Lexus tyre pressure and size guide

LEXUS MODEL YEAR FRONT SIZE / PRESSURE
NX 450h+ 2021 > 235/50 R20 / 2.5 bar or 36 psi
ES 300h 2019 > 215/55 R17 / 2.4 bar or 35 psi
ES 300h 2019 > 235/45 R18 / 2.4 bar or 35 psi
ES 300h 2019 > 235/40 R19 / 2.3 bar or 33 psi

Is 35 psi too high for tires?

Higher pressure generally is not dangerous, as long as you stay well below the “maximum inflation pressure.” That number is listed on each sidewall, and is much higher than your “recommended tire pressure” of 33 psi, Gary. So, in your case, I’d recommend that you put 35 or 36 psi in the tires and just leave it there.

What tire pressure is good for Lexus NX 300?

32psi
Lexus NX300 Tyre Pressure
This tyre placard recommends a minimum tyre pressure of 32psi for the 2020 Lexus NX300. This is equal to 220kPa and 2.2bar.

Should my tires be 32 or 35 PSI?

Ideal Tire Pressure
Tire pressure between 32 to 35 PSI is most suitable for most vehicles. However, one can go as low as 20 PSI (although that is not recommended). Anything below 20 PSI is considered a flat tire. PSI stands for Pounds per Square Inch.

How do you reset the tire pressure light on a Lexus NX 300?

Using the TPMS Reset Button
Turn the vehicle’s ignition to “on” without starting the engine; hold the TPMS reset button until the light flashes three times and release the button. Start the car and give it about 20 minutes—the warning light should disappear.

How do I know which tire is low on air?

All you have to do is push your thumb down on the tire to feel the pressure. Underinflated tires will be soft. You will find your tires to be extremely stiff if they are overinflated. The tire pressure is proper if your tire is not too soft or too stiff as mentioned above.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment