What is the minimum thickness of Honda brake pads?

The minimum thickness of Honda brake pads can vary depending on the specific model and year of the vehicle. However, based on the search results, here is the information I found:
– The minimum thickness for Honda Odyssey brake pads is specified as 1.6 mm in the service manual for the 2011 model.
– The standard thickness range for front brake pads on Honda vehicles is 10.5-11.5 mm (.041-.045 in).
– Most car mechanics agree that the bare minimum brake pad thickness is 3.2 mm ( inches).
– New Honda brake pads typically have a thickness of around 10-12 mm for the front pads and 8-10 mm for the rear pads.
– When new, Honda brake pads are 8 to 12 mm thick. They should still have plenty of stopping power if they are 6.4 mm thick, but once they wear down to 3.2 mm, they need to be replaced as soon as possible to avoid potential brake failure.
– The halfway point for front brake pad life is typically around 8 mm.
It’s important to note that these measurements are general guidelines and may vary depending on the specific Honda model and year. It’s always recommended to consult the vehicle’s service manual or contact a Honda dealership for the most accurate information regarding brake pad thickness for a specific Honda vehicle.

How long can you drive on 2mm brake pads?

At 2 mm pad you can be sure that you need to replace pads, but the rotors may still be above minimum thickness, but you let it get to 0mm pads, rotors are guaranteed to need replacement. In an emergency you could drive upwards of say.. 100 miles or so BUT they really need changing NOW.

How long will 3mm brake pads last?

Depends on the quality, the type of material and how much you want to stand on the brakes. 3mm is a little over a tenth of an inch. A cautious driver with a gentle foot it could go for a couple of months. A young man with a high performance car might go a week.

Is 3 mm OK for brake pads?

Most manufacturers and mechanics will all agree, though, that you should probably replace your brake pads once they wear down to 3mm.

When should I replace my Honda brakes?

That being said, Honda brake pads will typically need to be replaced every 40,000 to 50,000 miles.

Is 2 mm brake pads good?

New pads are about 10-12 mm thick and wear slowly at first, they seem to wear out more quickly towards the end of their life. You should replace brake pads at about 2 to 3 mm. There is normally a groove in the pads, once this disappears, it is time to change.

What if 4mm of brake pads are left?

Typically, 4mm of brake pad is recommended, so if you think they’re thinner than that, it’s time to get them checked and possibly replaced. This is the easiest way to keep on top of your brake pad condition and…

Is 4.5 mm brake pads good?

Typically, 4mm of brake pad is recommended, so if you think they’re thinner than that, it’s time to get them checked and possibly replaced. This is the easiest way to keep on top of your brake pad condition and requires no tools or training to carry out.

How long will 4mm of brake pads last?

I assume you mean pads with 4 mm remaining. New pads are around 1/2 inch (1 cm) of depth, and last (me) 50,000 miles. That’s 10mm per 50,000 miles, or 1mm per 5,000 miles. For me they would probably go around 20,000 miles.

How long will 4mm on brake pads last?

I assume you mean pads with 4 mm remaining. New pads are around 1/2 inch (1 cm) of depth, and last (me) 50,000 miles. That’s 10mm per 50,000 miles, or 1mm per 5,000 miles. For me they would probably go around 20,000 miles.

How bad is 2mm on brakes?

We’ll usually recommend brake pads at 2 or 3mm. However, we’re never going to say that the brakes aren’t safe, or you shouldn’t drive, or any other scary stuff. If you ask if you can wait a month or two, the answer is yes, you’ll likely be fine.