What is the maintenance required light on a Toyota FJ?

The maintenance required light on a Toyota FJ Cruiser indicates that a service interval has been met. This light is standard in all newer Toyota vehicles and helps ensure long life and dependability by making sure factory maintenance intervals are met. The intervals for maintenance typically occur every 5,000 miles or 6 months.
To reset the maintenance required light on a Toyota FJ Cruiser, you can follow these steps:
1. Turn the ignition key to the “Off” position.
2. Press and hold the odometer reset button.
3. While holding the button, turn the ignition key to the “On” position.
4. Continue holding the button until the maintenance required light goes off. This may take approximately 5 seconds.
5. Release the odometer reset button.
6. Start the engine to ensure that the maintenance required light has been reset.
Please note that it’s important to follow the recommended maintenance schedule for your Toyota FJ Cruiser to ensure its optimal performance and longevity. If you have any specific questions about maintenance or need further assistance, feel free to ask!

What does maintenance required message mean on Toyota?

Unlike the “check engine” light, the Toyota Maintenance Required light in the gauge cluster—which reads “MAINT REQD”—means that it has been 5,000 miles since the last reset. This indicates that your Toyota is due for scheduled maintenance, such as an oil change.

What happens if you don’t reset maintenance light?

Ignoring this light may seem harmless, but doing so could lead to gradual engine wear, reduced performance and even severe engine damage over time.

How long can you go after your car says maintenance required?

In general, a flashing oil light will turn into a serious problem after around 2 weeks or 500 miles of driving. However, once it reaches that stage, things can quickly deteriorate, resulting in catastrophic mechanical damage. As a result, schedule an appointment with a mechanic as soon as possible.

Is it OK to drive with maintenance required light on?

It’s not something you should worry about, but it’s best not to wait and consult your car’s maintenance schedule. When the maintenance required light comes up, it usually means that you need to change your vehicle’s oil and the oil filter, rotate the tires, or inspect the level of various fluids.

Does maintenance required only mean oil change?

Depending on the vehicle’s mileage, this could mean that an oil change, fluid check, tire rotation, or multi-point inspection is needed. In some cases, it may also be necessary to replace the wiper blades or cabin air filter.

How do you reset the maintenance light on a Toyota FJ?

We’re gonna turn off the key. Hold down the trip button turn the key you can see little dashes go in there they’re counting.

Is maintenance required the same as check engine light?

The maintenance required light goes on when your car is due for routine service. Examples of routine services include an oil change. However, the check engine light is an indication that something unexpected has occurred.

How long can you drive with maintenance required Toyota?

It only acts as a reminder that it’s time to take your Toyota in for a service, as it usually lights up every 5,000 miles or six months. There aren’t any real issues with driving your Toyota while the light is active as long as you know you’ve had the proper services done, or you’re planning on getting them done soon.

Does maintenance required mean oil?

It normally reminds you every 5,000 miles to make an oil change, filter replacement, and inspection. The light never indicates a problem with your car. The ‘check engine light is a far more significant warning than the ‘maintenance’ light.

How do I clear the maintenance required light?

Quick and Easy Steps to Reset the Maintenance Required Light

1. 1 Turn your car on, but do not start the engine.
2. 2 Change the dashboard display to “TRIP A.”
3. 3 Switch your car off and hold the “ODO/TRIP” button down.
4. 4 Start your car, but don’t turn on the engine.
5. 5 Hold the “ODO/TRIP” button down for 10 seconds.