AHG Auto Service » Make » Dodge » What is the code P0750 on a Dodge Ram 1500?

What is the code P0750 on a Dodge Ram 1500?

About Code P0750 on a Dodge Ram 1500
The code P0750 on a Dodge Ram 1500 indicates a specific issue related to the transmission. It refers to a Low/Reverse Solenoid Circuit Malfunction. This fault can put the vehicle into a state known as “limp-in mode,” where it may be limited to operating in a specific gear or set of gears, typically 4th gear. The P0750 code is associated with the LR (Low/Reverse) solenoid circuit, and it can be caused by various factors such as issues with the LR solenoid, Transmission Control Module (TCM), Powertrain Control Module (PCM), or any wiring between them.
Symptoms and Effects
When the P0750 code is triggered, the vehicle may experience symptoms such as being stuck in 3rd gear, an inability to shift into overdrive, or being limited to lower gears. Ignoring the code and continuing to operate the vehicle as usual can lead to a failure in shifting out of gear and may eventually limit the vehicle’s speed to only 35 mph. It’s important to address this issue promptly to prevent potential severe damage to the transmission.
Repair and Replacement
The P0750 code typically requires attention to the transmission solenoid pack, which contains multiple solenoids responsible for regulating fluid pressure to various transmission components. In most cases, the solenoid pack must be replaced as a single component. This involves accessing the transmission and removing the valve body, but it does not necessarily require the replacement of the entire valve body.
Conclusion
In summary, the P0750 code on a Dodge Ram 1500 points to a malfunction in the LR solenoid circuit of the transmission, which can lead to the vehicle being placed in limp-in mode and experiencing limitations in gear shifting. Prompt attention to this issue, including potential replacement of the solenoid pack, is crucial to prevent further transmission damage and ensure proper vehicle operation.

Can I replace transmission solenoid myself?

Once it is determined that you have a failed transmission shift solenoid the only repair is to replace the faulty part. Replacing a transmission shift solenoid can be done by most any auto repair shop, automobile dealership service center or you can do-it-yourself “DIY”.

Can you replace a shift solenoid yourself?

Once it is determined that you have a failed transmission shift solenoid the only repair is to replace the faulty part. Replacing a transmission shift solenoid can be done by most any auto repair shop, automobile dealership service center or you can do-it-yourself “DIY”.

How do you fix the code P0750?

In some cases, you can solve a P0750 code with a simple transmission fluid change or refill. First, you’ll have to perform a thorough visual inspection of your transmission fluid: is it still clean, or has it turned dirty over time from debris and other contaminants?

How much is it to replace a shift solenoid on a Dodge Ram?

The average cost for a Dodge Ram 2500 Auto Trans Brake Shift Interlock Solenoid Replacement is between $199 and $212. Labor costs are estimated between $53 and $67 while parts are typically priced around $146.

Can I still drive my truck with a bad shift solenoid?

Is It Safe to Drive With a Bad Solenoid? You can still drive your vehicle even if it has a malfunctioning transmission solenoid. However, it isn’t recommended. Driving with a bad transmission solenoid can damage your transmission even more, leading to costly repairs.

What are symptoms of a bad shift solenoid?

You may discover that the transmission will not shift out of neutral, as the solenoid is not receiving the proper signals or opening enough to shift the transmission. The gear shifts may seem rough or erratic, leading to a shaky or rocky feeling in the vehicle when you attempt to shift gears, accelerate, or decelerate.

What happens when a shifter solenoid goes bad?

Plenty of transmission shifting problems can be traced back to a malfunctioning shift solenoid, including: Delayed or unpredictable gear shifting. If you experience a delay in shifting, or your vehicle has ever jumped to another gear on its own, there is a very good chance that one or more solenoids are failing.

How much does it cost to fix a faulty transmission solenoid?

approximately $250
Depending on the make, model, and year of your vehicle, transmission solenoid replacement costs can vary. In general, a single faulty transmission solenoid replacement costs approximately $250. Replacing the entire solenoid pack can cost around $400.

How much does it cost to replace the shift solenoid?

$200 to $500
The overall cost to replace the shift solenoid in an automatic transmission ranges from $200 to $500 for a single solenoid. If the damage requires you to replace the entire solenoid pack the cost increases to between $250 and $700.

Where is the shift solenoid a located?

Usually, the shift interlock solenoid can be found underneath the vehicle’s shifter console, which is near the shifter lever on the transmission. The shift interlock solenoid prevents the gear shift lever from moving unless the driver pushes the brake pedal.

AHG Auto Service

At AHG, we are committed to always providing our Perth customers with the best service and benefits when it comes to their vehicle servicing and repair needs. We have over 30 passenger and commercial vehicle dealerships in WA and can handle all of your car servicing needs no matter the make or model.

Leave a Comment