What battery does a 2017 Ford Explorer key fob take?

The 2017 Ford Explorer Key Fob Battery Type
The 2017 Ford Explorer’s key fob takes a CR2025 battery, which can be easily found at most major retailers like Walmart and Amazon. You can expect to pay a few dollars for a single battery, and if you buy a pack of 5 or more, the cost per battery will likely dip below a dollar.
How to Replace the Battery in the Key Fob
To replace the battery in the key fob, you can refer to your Owner’s Manual under “Keys and Remote Control.” It’s important not to wipe off any grease on the battery terminals or on the back surface of the circuit board. When disposing of batteries, it’s advisable to refer to local regulations. Replacing the battery does not erase the programmed key from the vehicle. If you need assistance, you can take all your keys to your Ford Dealer.
Additional Information
It’s worth noting that the 2017 Ford Explorer key fob uses a CR2025 battery, and it’s important to use the correct type of battery as different key fobs may require different batteries. The integrated key-head transmitter takes 2032 batteries, but the Intelligent access transmitter takes 2025 batteries.

What size battery for a 2017 Ford Explorer key fob?

You can pop that battery out and it says these are CR 20 cr2025 batteries and they tells you to change both batteries at the same. Time.

How do you reset the key fob on a 2017 Ford Explorer?

Reset a Ford Key Fob: Step-by-Step Guide

1. Only open the driver side door and push the “Unlock” button.
2. Turn the ignition to “Off” then to “Run” eight times in a ten-second window.
3. You want the ignition to end on “Run” to enter the programming mode.
4. The doors of your Ford vehicle will lock and unlock several times.

What kind of battery for 2017 Ford Escape key fob?

CR2032 3V
Key Battery Replacement for Ford Escape (2001-2023 Model Years, Standard & Flip Key Remote Battery CR2032 3V)

How do you start a 2017 Ford with a dead key fob?

The door by inserting the key and turning to the right. Once you’re inside remove. The rubber covering from the bottom of the cupholders by pulling up on the tab.

Does it matter what battery I put in my key fob?

Most car key fob batteries use a standard watch battery, the CR2032 coin cell, but it can vary, depending on the year, make and model of your car. For instance, the Honda CR-V needs a CR1250 battery.

Can I use 2032 in Ford key fob?

Rome Tech CR2032 battery for car remote key compatible with Ford Fusion 2007-2016, Edge 2007-2016, Explorer 1998-2016, 2018-2022. Please, check your car model and the year before purchasing! Match your key fob with image 2 to confirm that the RTB CR2032 3V lithium battery suits your crucial fob.

Can you use a 2032 battery in place of a 2025?

For as long as either fits in the battery compartment, the CR2025 and CR2032 may be used interchangeably with minimal effect although the CR2032 would probably last slightly longer simply because it has a higher capacity (mAh).

How do you change the battery in the key on a 2017 Ford Explorer?

And just pop out the old 2450 battery take that out the new one goes in positive side facing up make sure you click in these two clips. Here put this in this side. First give it a good squeeze.

What battery does Ford Explorer key fob use?

Lithium CR2450
Lithium CR2450. This will fit Ford Smart Key FOBS! Battery (Single Use).

What size battery goes in a Ford key fob?

Most Ford key fobs operate on two CR2032 batteries, which are 3-volt lithium batteries. Though Ford key fobs can be square, rounded or rectangular, almost all use the same CR2032 batteries. An exception is the Ford Smart Key with Pull-out Valet Key, which comes with newer vehicles such as the Edge and Mustang.