How to take a tire off a Dodge Ram?

Removing a Tire from a Dodge Ram
To remove a tire from a Dodge Ram, you can follow these general steps:
1. Locate the Spare Tire: The spare tire on a Dodge Ram 1500 is located near the rear of the truck, just under the truck bed.
2. Access the Spare Tire: In order to access the spare tire, you may need to remove the wheel well cover. Once the cover is off, you will see the spare tire and the jack. The jack is located in a black plastic box and is held in place by two bolts.
3. Use the Proper Tools: It’s always best to have a proper jack and wrench with you when changing a tire. If you need to change a flat tire on your Dodge Ram 1500, it’s recommended to have a spare tire tool kit on hand, which includes everything you need to get the job done quickly and easily.
4. Lower the Spare Tire: To remove the spare tire, you may need to use a wheel wrench and a jack extension tube. Attach the wheel wrench to the jack extension tube, insert the tube through the access hole, and rotate the wheel wrench handle counterclockwise until the spare tire is on the ground with enough cable slack to allow you to pull it out from underneath the truck.
5. Consult the Owner’s Manual: The exact process may vary slightly depending on the specific model and year of your Ram 1500. It’s always a good idea to consult your vehicle’s owner’s manual for detailed instructions and safety precautions.
6. Safety Precautions: If you’re removing the spare tire for storage or other purposes, ensure it is stored in a safe and secure location.
Remember, these are general steps, and it’s important to consult the specific instructions for your Dodge Ram model and year for the most accurate guidance.

Where is the jack on a 2017 Ram 1500?

Pull that out and you’ve got access to your tools right. There. There’s a little clip in the corner. You undo that it releases everything and everything you need to change your tire is right. There.

What size jack do you need to lift a Ram 1500?

Lifting the front of the vehicle usually equates to raisinG60 percent of the truck’s weight because the engine contributes the most to the overall heaviness of the vehicle. A 2 ton jack is not capable of lifting a dodge ram 1500, you will want a 3 ton jack.

Where do you put the jack on a Ram 1500?

Then slowly lower your vehicle until it is stable on the jack. Stand. You can now remove the wheel if needed for safety slip it under the vehicle as additional protection.

Where do you place a jack when changing a tire?

So they should go on fairly. Easy. Just start them all and then use the wrench spin them on so they’re tight. And then do a star pattern.

How do you get a spare tire off a RAM?

When the spare is clear tilt. The retainer at the end of the cable. And pull it through the center of the wheel. Now loosen but do not remove the wheel lug nuts by turning them counterclockwise.

Do Ram trucks have a spare tire?

Pull that out and you’ve got access to your tools right. There. There’s a little clip in the corner. You undo that it releases everything and everything you need to change your tire is right. There.

How do you remove the jack on a 2017 Ram?

To replace the jacket reverse steps listed in this video place the jacket under the passenger side seat. Put the wing Boldin. And screw back in until tight you.

How do you jack up a truck with a floor jack?

Slowly pump the jack handle until the front wheels leave the ground, then stop jacking and double-check the jack placement. Look at the front of the vehicle to make sure it’s not leaning to one side. If it is, lower and recenter the jack. Otherwise, continue pumping until the vehicle reaches the desired height.

How do you jack up a truck to change a tire?

Raise the truck up by fitting a jack under it.
Lift it so the wheel is about 6 in (15 cm) off the ground. For safety, position the jack along a metal part of the frame rather than the plastic exterior. Check the owner’s manual if you are unable to locate the jack point just by looking at the truck.

Is it OK to remove spare tire?

Removing the spare can reduce a vehicle’s weight by up to 50 pounds, including the jack and lug wrench. It can also improve aerodynamics by reducing air drag from a spare tire that sits below the undercarriage of a vehicle. These two factors can affect a vehicle’s MPG. To save space and weight.