How to remove axle from Ford Focus?

To remove the axle from a Ford Focus, you can follow these steps:
Removing the Axle
1. Prepare the Car: Remove the rotor and caliper, and twist the hub to create room for the axle to come out. Use an air hammer or a 4×4 chunk of wood and a hammer to help remove the axle from the hub. Be ready for some fluid to come out when removing the axle from the transmission.
2. Pry the Axle Out: You can pry the axle out by removing the battery and battery tray, and using a pry bar from under the fuse box to pry out on the axle and pop it loose. It may also be necessary to use a pry bar to carefully pry the axle out from between the tranny and inboard CV.
3. Use the Right Tools: You might need a puller to remove the axle from the hub. It’s recommended to rent a heavy-duty 3-jaw puller from your parts store just in case, and make sure it has a good spinner with it. Additionally, a dead blow hammer can be cautiously used to tap the axle in while pushing.
These steps should help you remove the axle from your Ford Focus. Good luck with the repair!

How do you pop an axle out?

Put it on over here. And you want to take the hammer. And you want to drive out the axle. That way or you can use a pickle fork you can also put up against the axle. And again use a hammer.

What can I use instead of a slide hammer?

And we put a vice grip with a chain. Brought the chain out about this long put a bolt through it with a slide with a sledge hammer. And we’re able to use the sledge hammer. As a slide hammer.

What causes an axle to come out?

Things that can break your vehicle’s axle include poor maintenance; an auto accident; hitting curbs, potholes, or bumps too hard; and overloading your vehicle beyond its weight-bearing capacity. The axle is responsible for transferring the engine’s power and transmission’s torque to the wheels.

How do you pop a CV axle joint back in?

It. There it goes. You see how i did that so i basically just rotated the brake rotor. Until this was lined up back on the inside of the boot. Now obviously this is broken.

Can I use a pickle fork to remove CV axle?

I used a pickle fork as a wedge and pounded it in and the shaft popped out. For me getting the new one in was the harder part. It took a few whacks with a big hammer and a big brass chisel, but it popped right out.

Can I remove my front CV axle and still drive?

A four-wheel drive vehicle can be driven without the front axles , but it will not be as effective in off-road situations.

Can you replace axles yourself?

You absolutely can replace your CV axle at home, but you’ll need to be at least remotely comfortable using a jack, jack stands, and power tools. Assuming you have most of the equipment already set up in your garage at home, the cost to replace your CV axle will be quite reasonable.

How do you remove an axle nut without a tool?

Go ahead and get your wheel and pop the center cap. Off. Go ahead and put the wheel back on and lower down the vehicle.

Do you need a special tool to remove CV axle?

You’ll need many tools and equipment to perform a front axle replacement, such as a breaker bar, a jack, jack stands, a pry bar or a CV axle puller, and a ratchet and socket set. Don’t drive on a bad CV axle because it can cause problems for the front steering and suspension.

How do you remove an axle without a slide hammer?

You’re not going to hurt. Anything. Take your rotor off put it aside. And out comes your axle shaft. Might have to make sure to plate this connect. There you go did it without a slide. Hammer.