How to check transmission fluid in a 2007 Ford Explorer Sport Trac?

How to Check Transmission Fluid in a 2007 Ford Explorer Sport Trac
To check the transmission fluid in a 2007 Ford Explorer Sport Trac, you can follow these steps:
1. Locate the transmission fill plug: The transmission fill plug and fluid level indicator assembly is located on the passenger side front portion of the transmission case.
2. Remove the fill plug: Use a wrench or socket to remove the fill plug. It is a 19mm plug.
3. Check the fluid level: Once the fill plug is removed, you will see a small plastic dipstick under the cap. This dipstick is used to check the fluid level. Adjust the fluid level as needed by pumping fluid into the hole and checking it with the dipstick.
It’s important to note that some Ford Explorer Sport Trac models may not have a transmission fluid dipstick. In these cases, the transmission fluid level can only be checked by a mechanic with a hydraulic lift or underground bay.
Remember to always consult your vehicle’s owner’s manual for specific instructions and safety precautions when checking or adding transmission fluid.
I hope this helps! Let me know if you have any other questions.

Do you check Ford transmission fluid in park or neutral?

Leave car in neutral or park. Let engine warm up and continue to run throughout operation unless vehicle’s owner’s manual says otherwise. (Be aware that some automatic transmission fluid levels are checked with the engine off.

How to check transmission fluid level when there is no dipstick?

Number one check it on a level surface. Number two check it in park. Number. Three check it while it’s running number four check out an operating temperature to get the most accurate.

What are signs of low transmission fluid?

Here are the symptoms you can expect to witness when you’re low on transmission fluid.

• Grinding Noises.
• Shaking When Shifting.
• Delays Between Gears.
• Transmission Slipping.
• No Shifting at All.
• Transmission Overheating.
• The Check Engine Light.
• It Smells Like Something Is Burning.

Where do you check the transmission fluid on a 2007?

Now we’ll take our long funnel. And place it in the tube we remove the transmission dipstick. From. Once the funnel has been inserted you can begin adding fluid.

How much does it cost to change the transmission fluid in a Ford Explorer?

Transmission Fluid Change Cost Estimates
The average cost for a Transmission Fluid Change is between $378 and $415 but can vary from car to car.

How often should you flush the transmission on a Ford Explorer?

After this first belt inspection, belts will be checked at every other oil change. Every 150,000 miles, the automatic transmission fluid should be changed, and the accessory drive belts will be replaced if they haven’t been changed out in the last 100,000 miles.

What happens if you drive with low transmission fluid?

Low fluid levels can cause gears to miss, which will result in a grinding sensation. The occasional slipped gear might seem like a small issue at first, but it’s always a good idea to have the transmission looked at when this occurs to avoid costly repairs in the future.

What happens when transmission fluid is low?

One major sign of low transmission fluid is overheating. If there’s not enough fluid to cool everything down, you may notice a burning smell or see smoke coming from your car. If left alone this can lead to a loss of power or other permanent damage, so seek assistance from a service center right away.

What kind of transmission fluid does a Ford Explorer Sport Trac take?

Motorcraft – MERCON® LV Automatic Transmission Fluid ATF, 1 Quart (Part No. XT10QLVC) The only parts recommended by Ford Motor Company for Ford, Lincoln and Mercury vehicles.

How do you check the transmission fluid on a Ford Explorer?

It’s a little bit dirty so I’m gonna wipe it with a rag. You don’t want any of that getting into the transmission to check the fluid level on this vehicle in the transmission.