How to Change the Third Brake Light on a 2006 Dodge Grand Caravan
To change the third brake light on a 2006 Dodge Grand Caravan, you can follow these steps:
1. Start by opening the rear hatch or tailgate of the vehicle.
2. Look for four holes at the top of the third brake light assembly.
3. Remove two 10mm nuts from these holes.
4. Locate two plastic tabs on the sides of the assembly.
5. Squeeze the tabs with long nose pliers and press forward to release them.
6. Lower the hatch or tailgate and pull back on the “spoiler” to access the two screws holding the light in place.
7. Remove the screws and carefully take out the old light.
8. Replace it with the new third brake light.
9. Reassemble all the fasteners, making sure everything is securely in place.
10. Take your time during the process, especially if it’s your first time. Expect to spend around 30 minutes to complete the change.
Please note that the instructions provided are based on a search result snippet from CarGurus. It’s always a good idea to consult the vehicle’s manual or seek professional assistance if you’re unsure about any step.
I hope this helps! Let me know if you have any other questions.
Contents
- What year did 3rd brake lights come out?
- Can you get pulled over for a broken third brake light?
- Does brake light switch control 3rd brake light?
- Where does the third brake light go?
- Does the third brake light matter?
- Where does the third brake light need to be?
- What is the center brake light called?
- Why is my third brake light not working properly?
- What is the third brake light called?
- Where is the third brake light located?
What year did 3rd brake lights come out?
1986
As a result, in 1986, NHTSA began requiring all new cars to have a third brake light. The agency extended that requirement to all new light trucks in 1994.
Can you get pulled over for a broken third brake light?
Yes, a cop can pull you over for a busted tail light under the broken tail light law.
Does brake light switch control 3rd brake light?
If the brake switch was bad, the 3rd brake light would not work. It’s primarily a problem with the turn signal switch since the hazards and stop lights both are on the same circuit.
Where does the third brake light go?
The position of the third brake light varies according to different cars. Usually, you can find it installed inside the back glass of the vehicle. It can be located in the car’s deck lid. For a few trucks, the third brake light may be located on the spare wheel carrier.
Does the third brake light matter?
According to his findings, the third brake light significantly improved the safety of drivers. In fact, having a third brake light prevented collisions and reduced damage to the cabs in the study.
Where does the third brake light need to be?
The CHMSL must be on the vehicle’s rear center line, at least 34″ from the ground (see Figure 1).
What is the center brake light called?
Center High Mounted Stop Lamps (CHMSL) have been standard equipment on all new passenger cars sold in the United States since model year 1986 and all new light trucks since model year 1994, as required by Federal Motor Vehicle Safety Standard 108.
Why is my third brake light not working properly?
 If the inoperative third light flashes, with the emergency flashers, a fuse is the most likely cause. If it does not operate with the flashers, bad bulbs or sockets in the third-light are likely. Many modern third-brake lights use an LED and do not have bulbs that can be replaced.
What is the third brake light called?
CHMSL stands for the center high-mounted stop lamp. In a vehicle, the CHMSL is mounted above the left and right brake lights (also called stop lamps).
Where is the third brake light located?
The position of the third brake light varies according to different cars. Usually, you can find it installed inside the back glass of the vehicle. It can be located in the car’s deck lid. For a few trucks, the third brake light may be located on the spare wheel carrier.
