How to change the oil in a Subaru Outback?

Steps to Change the Oil in a Subaru Outback
Changing the oil in a Subaru Outback is a relatively straightforward process. Here are the general steps to follow:
1. Gather the necessary equipment: You will need at least 5.1 quarts of 0w20 synthetic oil, an oil filter, a drain plug gasket, ramps (optional), an oil drain pan, a socket wrench with a 17mm socket, an oil filter cap wrench (optional), a torque wrench (recommended), a funnel (recommended), and paper towels/newspaper for protection and clean-up.
2. Warm up the engine: Let the engine idle for approximately 10 minutes to ease draining the engine oil.
3. Locate the drain plug: The drain plug is typically located on the bottom of the engine oil pan. Place the oil drain pan underneath the drain plug.
4. Drain the oil: Use a socket wrench with a 17mm socket to loosen and remove the drain plug. Allow the old oil to drain completely into the oil drain pan.
5. Replace the drain plug: Once the oil has completely drained out, wipe the seating surface and around the drain plug with a clean cloth. Then, tighten the drain plug securely with a new sealing washer.
6. Replace the oil filter: Locate the oil filter, which is typically located under the hood. Remove the old oil filter and clean the rubber seal seating area at the bottom of the engine. Install the new oil filter by hand turning, being careful not to twist or damage the seal.
7. Add new oil: Use a funnel to pour the new 0w20 synthetic oil into the engine. Refer to your vehicle’s manual for the recommended oil capacity. It is generally recommended to add the oil in small increments and check the oil level using the dipstick to avoid overfilling.
8. Check the oil level: After adding the new oil, use the dipstick to check the oil level. Ensure that the oil level is within the recommended range.
9. Clean up: Wipe any spilled oil and clean the surrounding area to ensure a clean workspace.
It’s important to note that these steps are a general guide, and it’s always recommended to consult your vehicle’s manual for specific instructions and recommendations for your Subaru Outback model.
Remember, if you’re unsure or prefer to leave the task to professionals, you can always contact a Subaru dealership or service center to schedule an oil change appointment.
I hope this helps! Let me know if you have any other questions.

How long can Subarus go without an oil change?

The best place to start is with your Subaru’s owner’s manual. Most newer models can typically go between 5,000 and 7,500 miles between changes. However, if you’re driving an older model, you might need to change it more frequently.

How many quarts of oil does a Subaru Outback take?

4.4 quarts
A 2023 Subaru Outback takes 4.4 quarts of oil. How much oil you should use depends considerably on the type of car, engine size, and type of oil.

Can you change your own oil on a Subaru?

Unlike other car maintenance tasks, changing your engine oil is something you can do on your own. If you are new to this process, it can take around an hour but subsequently, you should be able to manage in half an hour.

How often should I change the oil in my Subaru Outback?

every 6,000 miles
You’ll have to get an oil change every 6,000 miles or six months, whichever comes first. If you’re not sure how long it’s been since your last Subaru oil change, your vehicle will exhibit a few signs that’ll let you know it’s time for fresh oil. Some of them include: Excessive engine knocking.

What is the best oil for Subaru Outback?

Like the Crosstrek, the oil for the Subaru Outback needs to be an API classification SN or ILSAC GF-5. Also like the Crosstrek, the Outback engine should be filled with 0W-20 synthetic oil. If synthetic oil isn’t available, you can use either 5W-30 or 5W-40 conventional oil.

What kind of oil should I put in my Subaru Outback?

Subaru Outback 2013 to 2023: 0W-20 Synthetic Oil. Subaru Outback (6-Cylinder) 2002 to 2019: 5W-30 Conventional Oil. Subaru Outback (6-Cylinder) 2020 to 2023: 5W-30 Synthetic Oil. Subaru Outback XT (Turbo) 2020 to 2023: 0W-20 Synthetic Oil.

Where is the oil drain plug on Subaru Outback?

The oil will drain the nicely. And also cracking open that filler cap right here. You see that yellow one. I will just open it like this.

Do Subarus need special oil changes?

No. Subaru Synthetic Motor Oil works with the same Subaru filters used with conventional motor oils.

Is it easy to change your own oil?

It’s not difficult to change the engine oil in your own car, but it can be messy and you could hurt yourself if you’re not careful. Find where the engine oil filler cap is. Usually it is somewhere on the top of the motor and will be coloured yellow (user serviceable item). Find what oil your car uses.

Where do Subarus usually leak oil from?

To detect common oil leaks in your Subaru vehicle, it’s important to check the most common areas where they can appear. These should include the rear of the engine, where your PVC baffle plate is located, as well as the piston access plugs and crank seal at the front of the engine, and the spark plug tube seals.