Transmission Fluid Capacity of a 2008 Chevy Cobalt
The 2008 Chevy Cobalt has a transmission fluid capacity of approximately 12.9 quarts when the transmission is dry. However, when only removing the lower pan, it typically requires around 7 quarts of transmission fluid. It’s important to note that more fluid may drain out during the process, so it’s recommended to add fluid until it flows from the hole to ensure it is full.
Please keep in mind that it’s always a good idea to consult your Chevrolet Owner’s Manual for specific information regarding your vehicle’s transmission fluid capacity and maintenance requirements.
Contents
- How much transmission fluid goes in a Chevy Cobalt?
- How much transmission fluid do I need?
- What are the most common problems with a 2008 Chevy Cobalt?
- How many quarts are needed for a transmission fluid change?
- How many quarts of transmission fluid does a 2009 Chevy Cobalt take?
- What problems are common with 2008 Cobalt?
- How much transmission fluid do I add if empty?
- How many gallons does a 2008 Cobalt hold?
- What transmission does a 2008 Chevy Cobalt LS have?
- Is 4 quarts enough transmission fluid?
How much transmission fluid goes in a Chevy Cobalt?
12.9 quarts
Automatic Transmission Fluid
4 speed 4T45-E Total Fill 12.9 quarts.
How much transmission fluid do I need?
How much transmission fluid your vehicle needs ranges from as few as 8-9 quarts for small passenger vehicles to more than 20 quarts for heavy-duty trucks. As you do when determining how often to change transmission fluid, check your owner’s manual for the transmission fluid capacity.
What are the most common problems with a 2008 Chevy Cobalt?
Top 2008 Chevrolet Cobalt Problems
- Ignition Key Stuck Due to Failed Shifter.
- Check Engine Light and Misfire Due to Ignition Module/Coil Failure.
- Broken Timing Chain.
- Check Engine Light Due to Gas Cap Issue.
- Ignition Key Stuck Due to Failed Shifter.
- Flush brake fluid every 60,000 miles.
- Check Engine Light Due to Gas Cap Issue.
How many quarts are needed for a transmission fluid change?
Drivers can expect to pay $125 to $250 for a transmission fluid flush service. This is approximately twice as much as a transmission fluid change. This is due in large part to the additional fluid required. A flush will take 12 to 22 quarts, while a fluid change requires 5 to 7 quarts.
How many quarts of transmission fluid does a 2009 Chevy Cobalt take?
For Automatic Transmission: 4T45-E….AF6
Capacity: | 4 speed 4T45-E Total Fill 12.9 quarts. |
---|---|
Capacity: | 7 quarts Initial Fill. |
What problems are common with 2008 Cobalt?
Top 2008 Chevrolet Cobalt Problems
- Ignition Key Stuck Due to Failed Shifter.
- Check Engine Light and Misfire Due to Ignition Module/Coil Failure.
- Broken Timing Chain.
- Check Engine Light Due to Gas Cap Issue.
- Ignition Key Stuck Due to Failed Shifter.
- Flush brake fluid every 60,000 miles.
- Check Engine Light Due to Gas Cap Issue.
How much transmission fluid do I add if empty?
If you notice the transmission fluid is a little low on the dipstick, start with a half a quart to a quart of transmission fluid. Recheck the level and add ¼ quart (or less) at a time until the level is up to the full or max mark.
How many gallons does a 2008 Cobalt hold?
13.0 gallons
Compare Side-by-Side
2008 Chevrolet Cobalt | |
---|---|
Annual Fuel Cost* | $1,900 |
Cost to Drive 25 Miles | $3.14 |
Cost to Fill the Tank | $43 |
Tank Size | 13.0 gallons |
What transmission does a 2008 Chevy Cobalt LS have?
LS and LT models use a 2.2-liter four-cylinder that makes 148 hp and 152 pounds-feet of torque. Sport models hold a 171-hp 2.4-liter engine. Both engines are available with a five-speed manual or a four-speed automatic transmission.
Is 4 quarts enough transmission fluid?
Vehicles require an average of 4 to 17 US gallons (3.8 to 16 liters) of transmission fluid to fill; the majority of automobiles contain between 12 and 16 quarts (11.3 to 15.1 liters), depending on the car’s manufacture and other criteria.