Based on the search results, it seems that there is no definitive answer to how much oil a 2010 Subaru Forester AC compressor takes. However, there are some general guidelines and estimates that can be considered.
According to a post on the Subaru Outback Forums, most Subaru vehicles hold roughly 6 ounces of oil in their AC systems. However, it is important to note that this is just a rough estimate and the actual amount may vary depending on the specific circumstances and components involved.
Another source on the same forum suggests that a rule of thumb is to allocate 50% of the PAG oil to the compressor, 20% to the condenser, 20% to the evaporator core, and 10% to all hoses. However, this is a general guideline and may not apply to every situation.
It is also worth mentioning that a used compressor typically comes with residual oil from the previous system, so adding additional oil may not be necessary. The new compressor may also pick up oil from within the existing system if needed.
Given the lack of specific information for the 2010 Subaru Forester, it is recommended to consult the vehicle’s manual or reach out to a Subaru dealership or an AC specialist for accurate and specific information regarding the oil capacity of the AC compressor in a 2010 Subaru Forester.
Contents
- How many quarts of oil does a 2010 Subaru Forester take?
- Do you add oil to a new AC compressor?
- How do I know if my car AC compressor has enough oil?
- How much oil does a 2010 Subaru 2.5 take?
- How much coolant does a 2010 Subaru Forester take?
- Do you need PAG oil for AC compressor?
- What kind of oil does a Subaru PAG take?
- Do I need to add oil when recharging AC?
- How much oil does an AC compressor take?
- Can you add too much PAG oil?
How many quarts of oil does a 2010 Subaru Forester take?
4.4 Quarts
Subaru Oil Guide:
| Model | Subaru Oil Required | Capacity |
|---|---|---|
| Subaru Forester 2002 – 2010 | 5W-30 Conventional Oil | 4.4 Quarts |
| Subaru Forester 2011 – 2021 | 0W-20 Synthetic Oil | 4.4 – 5.5 Quarts |
| Subaru Forester XT 2004 – 2010 | 5W-30 Conventional Oil | 4.4 Quarts |
| Subaru Forester XT 2011 – 2018 | 5W-30 Synthetic Oil | 4.4 – 5.4 Quarts |
Do you add oil to a new AC compressor?
Turn it upside down on the collection device for at least eight to ten. Hours. Once you drain the oil out of the compressor.
How do I know if my car AC compressor has enough oil?
If your vehicle lacks compressor oil, there will be some telltale signs like humming sounds, refrigerant leaks, burning smells, and visible smoking.
- Humming Sounds. If you hear a strange humming noise when switching on your car’s A/C system, you may lack compressor oil.
- Refrigerant Leaks.
- Burning Smell.
- Visible Smoke.
How much oil does a 2010 Subaru 2.5 take?
4.2 quarts
Oil Grade: SM
5W-30, 5W-40 – SAE 5W-30 is preferred. Capacity: With filter 4.2 quarts.
How much coolant does a 2010 Subaru Forester take?
RADIATOR COOLANT – 8.1L or 8.0L capacity.
Do you need PAG oil for AC compressor?
We get this question often. The fact of the matter is unless you are changing out the or another component in your A/C you probably will never have to worry about recharging PAG and Ester oils.
What kind of oil does a Subaru PAG take?
R-134a PAG 100 AC Oil Lubricant with ICE32 Lubricant Enhancer features advanced chemistry to help extend compressor life and improve cooling capacity. The PAG oil helps quiet noisy compressors. Meets OEM specifications.
Do I need to add oil when recharging AC?
If the system is unopened, there’s no need to add oil. If it was opened,oil is added through the charging port before the system is recharged.
How much oil does an AC compressor take?
The AC system in most modern vehicles needs a total of 4 ounces (120 ml) of oil. So, checking the manual is a good idea to be sure of the exact amount and to avoid over- or under-filling the system. A low level of oil may cause compression failure, and overfilling will also hurt cooling performance.
Can you add too much PAG oil?
Yes. AC systems are designed to have a certain amount of refrigerant and a certain amount of oil. Adding too much oil will hinder performance. If you add way too much oil, you displace refrigerant which is needed to cool the compressor and it could lead to compressor burn out.
